Jan 17 2009, 12:05 PM
QUOTE(nidzamputra @ Jan 15 2009, 06:38 AM)
if you dont like use manual beside you..just snap the picture whole your rig (all connection) then use when to assemble back...
QUOTE(mrpilot @ Jan 15 2009, 11:28 PM)
write on paper b4 plug out all cable n wires. 
QUOTE(kursk @ Jan 16 2009, 01:44 PM)
snap ur mobo pic first then connected all the wires according to the pic.simple as 1 2 3.if cannot be started,mean sum cable are not being plug tightly.
good luck~
all these tips up here are the ones i've done when i tried to install n uninstalled my 1st mobo....i mark every cable i see...easier to connect later...good luck~
T_S just remember to move ur mobo very2 carefull and not to mention put some gentle in holding it...
Quote
0.0139sec
0.71
6 queries
GZIP Disabled