No don't do like cheeann said (loosen drain plug). The drain plug gasket may go out of shape and leak. Instead go to any workshop and get the vacuum for oil suction.  Just suck out a little bit till the oil is at or below max.

Usually the workshop won't charge you or they charge you only a little bit.  In case they don't charge you, be a good customer and offer them 2 or 3 ringgit for their trouble.

Hahaha... I don't think I dare to DIY as I also don't know what is going to happen after that. But when I saw the engine oil level I really  How come Proton service center so "PROFESSIONAL" some more charge customer kaw kaw and also labor fees

Protect??? sure boh?? hahahaha

Or just a lazy reason " i don't care"

No brother, I don't consider myself smart but I try my best to help those in need. 

I do not know that the vacuum oil suction is rare in KL/PJ.

Here in Ipoh its pretty common.  If you're nice guy, they don't want to charge anything for minor stuff.

You're 100% right.  Hypro can still use a wrench an drain off the oil.  If he's careful enough he won't damage the aluminum gasket.

Good for you brother!  Don't DIY if you don't know how.  Just go to Ah Beng and he'll do it for you.  Don't go to SC.  They spend 2 hours to do what Ah Beng can do in 10 minutes. And then they will "send" it to another car wash (which you are not aware of) and this time come back with a dent on the panel.

Dunno how much they charge in KL/PJ area but in Ipoh, stuff like this its free or only a couple of ringgit.

Thanks for ur info, I tot is becoz of maybe it have some hole or curve design that leave the oil can not drain out

My engine oil is far above the MAX level as well. I haven't done my 1st service yet. 

Mine 11months already 31,000km. Every 3months going back to wives hometown (Terengganu)....

haih, i broke my car's virginity 

[attachmentid=1093240]

all persona fault, the car too nice to drive fast      

I'll try to answer about LCP. Since it's lighter, I'm guessing that there will be less momentum to make a rotation. A crank pully is the piece which converts all up down movement of piston to rotation movement to be transfered to the wheels. It should be located just outside your engine block (probably near the base as this point is where the pistons are connected by the crank)

Since it is lighter, it will have less inertia (more weight means harder to move). Therefore, using lighter crank pully will make it accelerate faster and stop faster. Same concept as lighter rim i suppose. Lighter means easier to stop and fuel saving... Just my 2 cents...

The round thing attach to your timing belt. I'm a noob too, but you can browse through here.... Lightened Crankpully / Lightened crankshaft, Come and discuss

Can open new thread already, V6.

Guys, anyone know how much does OZ Racing 15" rims roughly cost and where to get in KL/Selangor?

I was looking through the site, and these looks nice to me. What do you all think if it's fitted to Persona SE? Will look good?

Michelangelo 8

Michelangelo 10

Power

35th anniversary

Superturismo GT

Dear all,

Does anyone have a photo of the "drive shaft damper"?

I really need to make sure before sending my persona se to SC. I do not want to go there and find out that my car alredy came with it.

My problem is pedal vibration during 90 - 100km while driving at 2600 - 2800 rpm.

A real life photo is very much appreciated.

Thanks.

I have found out 3 picture, but don't know which one is Drive Shaft Damper.

picture 1 = drive shaft boot cover

picture 2 = drive shaft damper

picture 3 = drive shaft damper

I am also confuse which one is the real drive shaft damper, Can anyone verify it??

Normal, mine also especially if you break frequent
having same vibration problem also. go first service, they say checked and no problem....
not matter of balancing. i also went to do balancing, but the vibration persists although slightly less now

@ cheeann....my steering vibrate from 100km...lol........but if do balancing still same rite???   unless change tire

nope..dont think so....but some road like certain part of nkve not really vibrate but federal highway got vibrate.....any tires price around rm180-220??? wana change the front only....solve the vibration...   furthermore going PD....if drive 100km vibrate really sien..lor

I have try on ron 95, there is no different at all, pick up also ok, same with ron 97. The only different I can notice is "Price"

for the engine lube, I agree that, if they pour all 4L into the engine, it will feel sluggish, and slumber abit. So I suck out 250ml and I can feel better pick up, but fuel consumption is worst than before I suck it out.   I also don't know why