wow already v6...

like most ppl advice...try turning off Af function

Yeah Myvi is around that mileage. Even my mom's Myvi manual can only clock maximum 280KM-300KM for a full tank. It's consider very high FC for a manual car.

FOR ME
1. it is fuel efficient..check back my post....RM50 for 500+KM
2. pickup slow at 1st but fast after i shift to 3rd gear or 60KM/H
3. noise is noisy...because this saga almost no soundproof...just the floor have
other need u to do it yourself ....bonnet, door, fender, trunk etc.

flying stone chip just buy the touch up paint(solid white), and use fine paintbrush touch it up.

---

Added on December 29, 2008, 11:56 pmjust now i travel from kedah back to penang..at highway crusing, i saw the YELLOW engine light is "ON" ...D$$& scary...sudden and slight power loss because of that.  

but now i try to start the engine, no more YELLOW engin light..hmm

tomorrow have to send back SC.  

I see.

The paint primer and basecoat also being scratch away.

My engine bay really2 dirty n mouse make port rite there  ...erm..is it possible to wash it? afraid effect the electronic stuff there...

pic n brand of tis tire pls~ 

Understood your answer. I can't expect much from a RM40k car and it is made by Proton (no offence).
The reason why I consider Saga is I urgently need a car and as current economy situation, it is not so wise to get a foreign brand car. I am closely reading the reported problems and its FC before I put my signature on the hire & purchase. Thanks

i use auto...3 months already...so far no problem also...hope its ok...sometimes i pull the gear leaver quite rough..and not many times i put the gear at N when at traffic light..mostly i put it at D..some say this is not good...some say its ok..

Today changed my IAFM, took 4 hours to get it done...the IAFM quality same as those black plastic tong sampah =.=

toby.c13
aih?when u wanna tt with us?i wanna check out ur 3M tint..never saw 1 b4.

The tak tak tak sound lo...when u rev the engine u will hear tak tak tak tak if severe failure one the engine idling itself also will got that sound dy, i detected mine early.

Had the same problem before. Even running slightly rough roads also can heard the obvious noise from passenger side A-pillar. Initially thought the noise was from either dahsboard or side mirror. Went SC couple times and finally found the noise was actually coming from outside of the passenger side fender.    The join part between fender corner and bottom of A-pillar. There a gap between these 2 sheets of metal which might cause some irritating noise when car vibrates. 

You can either put some thin slice of rubber sheet in between and tighten the screw. Alternatively you can just use some force and pull the fender metal edge out abit then it may not possible to contact the A-pillar metal surface. The knocking may tunnel into A-pillar and give you the wrong impression that the noise is coming from inside the pillar. 

---

Added on February 4, 2009, 6:00 pm

Got some intermittent annyoing noise coming from clutch and brake pedal when step on it. According to SC this is quite common, maybe due to cheapo quality spring used on the pedal join. Mark some grease on it will solve the problem:)

after change the IAFM, the engine breathe better? performance?

this black modul starts from the air filter box to the engine that 1 ar?

I really wonder what is the logic behind this? coz i thought that if we rev too high not good for engine, on the other hand, it's good for FC? 
Eh btw, anyone experienced the "Phhfiii, PHfiii" sound (Like whistling while you are driving sometimes), i told SC yesterday (Fixed the module and the window and this) about that and they said it's a gap at the door and they narrowed the gap ~

But today ~~~ i sill hear the PHfiii PHfiii sound,since  2-4 days ago

hamsap spotted ! 
jk

feel free to right click and save.. only got that one pic

BTW, anyone can answer my previous question regarding the coolant?
can mix with other color?

our rear brake not using disc brake / brake pad...it's using drum brake
probably is the bearing already finish......need to change...refer to blm club for more info
our car's drum brake not balance....eat 1 side