TS,

this is subjective, some people prefer to have dedicated electric screw driver, it is more easier, for me i use my black n decker impact drill, switch it to normal drilling mode, attach the screw driver bit and just make sure u control the On/Off knob properly, not too fast if not u risk ruining the screw heads.... of coz the cheaper unbranded ayam X itik anjing brand will not have variable speed switch / knob, means when u press on, the drill will start spinning at its 100%, this type of power drill cannot be used for screwing things.... the black n decker RM 150++ above range is already able to support the variable speed switch function.....

of coz remember the wall plugs, and buy real good quality screws.... if the screws u use are the cheaper ones, better use back manual hand RM 5 screw driver if not the screw head's gonna kaput very fast with ur powerful electric screw driver.... unless u buy some high end with torque control units, which u can adjust and play with it to avoid excessive force......

u can also find some very long, more than 10 inch screw driver bit, just in case u need to get into somewhere deeper where a shorter screw driver bit can't access into....

This post has been edited by LightningRevenant: Dec 2 2008, 07:48 PM