Too interest in modding.
But those tools are too expensive.
Can i sleeving without any modding tools?

Yes you can.
You need a small pin to open the molex connector.

Then a hairdryer to shrink the heat shrink.

how do u put the pin in ???

Read the pinned guide on the sleeving PSU

The people in the guide using 1 pump tools to remove wire.
Do i need that also?

not really if u got two small flat head screw driver and lots of patience ..

you could still remove the wire but will take so much more time.

unless practice till perfect.

u also can use tweezers to remove the molex connector pin

u need to understand on how the wire connected to the molex.. it will be so easy if u understand it.. i completely sleeve my psu without using any sleeving tools.. just a small flathead screwdriver..

remember : when u wanna assemble the wire back, make sure it's in the right position.
i'd lost my 80gb hdd coz wrong position of wire in sata power cable

the safety method... use cellotape to stick the wires together before removing the connectors... so that it will be in right place after you put the connector in again..

i used screw driver to push the pin from the molex
and yes u need to mark ur wires first...
using masking tape and write number on it...

good idea

Patience is the hardest part. Esp dealing with the 24 pins . Dammit.

pergh..that 24 pins sure surrender lah.
coz my psu already sleeved that 24 pin.fuh..

Yup..safety 1st..b4 something happen..lol...
For backup..u can snap a picture & print it..
in case masking tape peel off during assy it..

yes,u can...try to google it...even in lowyat oso got sumone teach how

i also want to make sleeve the psu n wish me luck.

I sleeved mine.

So shouldn't be a problem.

Just that, I don't know why, all type of methods still can't get my 6 pin PCI-e and 4 Pin CPU out =.=

Plain wierd.

risau salah pin nanti boom pc nih ehehehe

Lol...It wont BOOM la...My fren tried it before, it only will melt the connector...

i think u can sleeve better wif the mod tool
u can`t just try to mod wif using hairdryer

tumpg thread..
if wrongly do, psu will rosak x?

Try go to "You tube" there might show you .

juz send o a pro la...
@ts how ur modd? any picta

haha first time try nak sleeving trus boleh ^-^ .. Sleeving is easy, seriously bro.. in the molex cover got the tiny 4 hole aite.. in each the hole slot, you could see the tiny 'PIN' that act like a holder for the wire.. hold the 'PIN' and pull away the tiny wire out of the molex cover ^-^ .. so simple mimple.. you need two basic tool that is flathead screwdriver and also lighter ^-^ ..

---

Added on November 5, 2009, 9:58 pmnever heard of sleeving the psu cable will made the psu 'KAPUT' hehe .. just do with a lot of patient, no need to rush, if you didnt finish by today, tomorow still can continue the sleeving ^-^ ..

This post has been edited by Sarbath: Nov 5 2009, 09:58 PM

this one da best idea ^^

hehehe, i was using hairdryer before i purchased the Bosch Heat Gun.

Hair Dryer need to wait more longer , now u using Bosch Heat Gun ?

Yup, using the Bosch GHG 600-3