u OC in bios or use utility?

if OC in bios do dis:

1) RAM timing set to auto.
2) in crease ur fsb bit by bit (5 or 10 each time), only increase ur fsb if it passes the POST, means can boot.
3) once u can't boot anymore, increase ur vcore by bit (+0.2), den try again.
4) repeat till u get the speed u wanted.
5) go in windows & run IntelBurn test for 3 - 5 round (monitor ur temp, stop if go above 90).
6) if test successful, congrat, u got a stable OC.

if OC wit utility, its very ez, just set ur fsb, multiplier & vcore, also increase.
but OC in windows might not b as stable due 2 RAM timing & it also doesn't need 2 pass the POST.

This post has been edited by tech3910: Sep 20 2008, 05:28 PM

dat apply if u hav performance or OC ram.
normal ram is different.

by default, mobo will automatically loosen the timing. otherwise, fail 2 boot...............

normal RAM can't handle too much ................x_x

This post has been edited by tech3910: Sep 20 2008, 11:14 PM

sure, dat is good.
wat is the purpose of u OC ing?
just wanna OC or wanna increase gaming performance?

for gaming performance 3.0 i actually enough. u can lower ur vcore.

hav 2 test for stability? (intelburn test)