QUOTE(jeffreymak @ Aug 23 2011, 11:55 PM)
Rodyeo,
From the pictures, i think R3293 is shinier than R3313. Please advise. From your comments on R3313, i believe my gf will fit nicely into R3313. Regarding the durability, I will let you know once my gf has tried on it.
So far, durability is good on R3200.
Added on August 23, 2011, 11:01 pmRodyeo,
Since you have tried R3313, would like to ask you where does the waistband end? At the hips? The waistband thick of thin?
Dear jeffreymak,
Unfortunately the flash optical illusion is a little bit deceiving... In actuality... R3293 is matted lycra material and more dull and less shine. Compare to R3313 which shine like mad when angle at 90 degrees to the light source.
Trust me my little brother is being squashed like compress sausages after just wearing it for 15 minutes... It is indeed tight fitting with medium support compression through the entire pantyhose... I decided to cut a vertical slit in between the cotton crotch and it was a relief for my little brother and my two other siblings to have sneaked out through the crotch slit... What a relief...
The waist band end is thin but followed by the extra sewing of nylon elastic thick rubberised band within the panty area which makes it non slip. The hips area is a clear material same like the leg part followed by the toe area which have an extra honey comb sewing reinforcements.
The waist band ends below my belly button if I pull up all the way and it is very tight stretch. I can nicely leave it just above my crotch ending base area if I want to wear it comfortably which is at the hip.
Durability for R3313 is extremely good because I internationally tried to nick a thread and it spring back to the base and leaves very small or not existance traces of the torn hole in existance.
As for the R3295 I did the same test but this the thread did not spring back so much but it locks the existing torn hole intact which did not make the pantyhose ladder yet.
Photos shortly follows...
rodyeo
This post has been edited by rodyeo: Aug 24 2011, 12:02 AM