No wonder..6000 Processor dont expect to push high..
bro pWs this is his problems

"Im ocing in AX78,
whenever i OC my cpu FSB to more than 220,
the bios will stuck at startup page and tell me to set the clock lower at Sofmenu. Is tht anythg i can do abt it?
all voltage is setting at their default value..
the cpu voltage default is 1.4V...
i hav to increase more?
i OCing with increase FSB, lower Multiplier, and then set HT multiplier to 4
did i miss some other setting?
and if i hav to increase vcore and vdimm voltage, how much shud i increase it? thank you"

my question at post #122

flashin bios in dos is a lot more safe than doin it in windows. it's not as scary as u think mate. 

loosen timing, increase v nb 1.1v to 1.17~1.20v, lower vdimm to 1.9v, put 12*300 instead, use divider 533 will do. 

ok edi.. digswell help me too yesterday.. thx -pWs- n digs

wrong getaway IP adress.....i still think y prolink hv to put xxx.xxx.xxx.254 as default getaway IP usually is XXX.XXX.XXX.1

A good lesson for those lazy to flash bios in dos.

Flash bios in dos is much eazy and fast then windows

Need advise. Is this RAM good?

KINGMAX 1GB DDR2 1066
．240-pin DDR2 1066MHz Long-DIMM
．CAS Latency：5-5-5, CL=5
．Memory bandwidth: 8.5GB/sec
．Voltage: 1.8V
RM95

Or should I go for Crucial Ballistic?

last batch.. i will try lowering it down..
didn't manage to tweak this ram properly.. 195ns..

@ -pWs-,

bro, not everyone so lucky to have a gud batch mah... mine almost d same too... 

[attachmentid=584308]