Welcome Guest ( Log In | Register )

17 Pages « < 8 9 10 11 12 > » Bottom

Outline · [ Standard ] · Linear+

 PROTON SAGA BLM CLUB V5, HOOORAYYY!! V5

views
     
MR_alien
post Nov 15 2008, 05:35 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(-storm- @ Nov 15 2008, 05:13 PM)
Washing detergent lo, those wash plate one, its really good it even wash away your car's wax.... thumbup.gif
*
oooicic...thx....haha
clorox can???
means use cloth and put those detergent and swipe it...thn wait till it dry thn install??

This post has been edited by MR_alien: Nov 15 2008, 05:44 PM
MR_alien
post Nov 15 2008, 08:35 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(-storm- @ Nov 15 2008, 08:08 PM)
Just mix the detergent with water and like wash car like that la, wash then dry and stick.
*
how bout send my car to carwash??....they say those chemical that they used to wash car is bad?
MR_alien
post Nov 15 2008, 09:20 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(-storm- @ Nov 15 2008, 08:46 PM)
The chemical use for tar removal one la...also very corrosive....
*
ooo...thx....thn can after send to car wash thn i use detergent water to clean the part that need to stic???
thn only i stick??
because my car is 2 month plus didn't wash.....super duper dirty with dirt!
MR_alien
post Nov 16 2008, 04:56 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(cypher_jy @ Nov 16 2008, 04:25 PM)
Finally, i had Ultra Racing front strut bar installed yesterday at Advan Racing, Seremban for rm110. Im very pleased with my cars handling after installing the sturt bar. I can take corners fast and confidently which i could not before.
user posted image
Now im thinking of installing the rear lower arm bar OR the anti-roll bar. My budget only permits for one. This is because when i take sharp fast corners, the front remains planted to the ground but the rear feels like its rolling over.

I need some advice on which bar should i install either the rear lower arm bar OR the anti-roll bar. May i know which bar has a greater effect on handling when installed and which points of the car does the 2 bars connect to?
*
wow....engine bay so clean....


Added on November 16, 2008, 4:58 pm
QUOTE(cypher_jy @ Nov 16 2008, 04:45 PM)
SiuYi
Before installing the bar i was scared to take fast corners coz the whole car feel like rolling over. Now i can say tht there is alot of handling improvement.
*
hahaha....with lotus handling...i dn't think it will...

This post has been edited by MR_alien: Nov 16 2008, 04:58 PM
MR_alien
post Nov 16 2008, 05:22 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(cypher_jy @ Nov 16 2008, 05:09 PM)
MR_alien
Looks clean ha  brows.gif , juz tht u can see the dirt.  tongue.gif
*
ya...clean....very clean....mine very dirty.....brown colour


Added on November 16, 2008, 5:23 pm
QUOTE(nazri86a @ Nov 16 2008, 05:18 PM)
brownies drive shaft... 2nd batch not having this problem...
*
u mean 2nd batch drive shaft dn't have problem???
and brownies??...food?

This post has been edited by MR_alien: Nov 16 2008, 05:23 PM
MR_alien
post Nov 16 2008, 05:34 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(nazri86a @ Nov 16 2008, 05:27 PM)
rusty... hehe

look here  shakehead.gif [attachmentid=674644]
*
oooh...that rusty pieces of steel.....i already forget about it...haha
so long already
how u know 2nd batch no problem??
tha pics also have rust
MR_alien
post Nov 16 2008, 05:53 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(nazri86a @ Nov 16 2008, 05:42 PM)
2nd batch engine bay  pic
*
where's the drive shaft???...the above silver one?
MR_alien
post Nov 16 2008, 07:56 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(michaeljack @ Nov 16 2008, 07:16 PM)
latest gen of saga's drv shaft now totaly anti-rust.
*
thn,if our 1st gen complain...will they change to anti rust one?
MR_alien
post Nov 16 2008, 09:36 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(cypher_jy @ Nov 16 2008, 09:27 PM)
My blm just reached 1000k mileage today. Planning to make an appointment with the SC this coming saturday. Besides changing the engine oil and oil filter what else will they change? Should i ask them to change the gearbox oil as well?
*
i dnt think so...they just change basic stuff
and they charge extra like windscreen wipe....but when u see it...they didn't wipe at all
and some of us even get charged for battery water....haha....crazy ppl
MR_alien
post Nov 16 2008, 10:09 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(cypher_jy @ Nov 16 2008, 10:00 PM)
torresism
So far from what ive read, installing the UR/3Max bars would not void warranty.


Added on November 16, 2008, 10:01 pmHas anyone installed the anti-roll bar yet? I think this would be my next bar, next month.
*
ya...cuz u add thing
only will void unless u change or modified the part
MR_alien
post Nov 16 2008, 10:42 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(ProX @ Nov 16 2008, 10:39 PM)
happen to me also...i sent my car to proton SC and they still cant figure out what happen...they are considering to replace me a new engine.

I think the air intake placement is not so practical because malaysian roads easily flooded during heavy rain (low and high level)..driving through it will cause the water to go into the engine via air intake..
*
hahhaa...it's the alarm system wire lah.....not the IAFM
MR_alien
post Nov 16 2008, 10:50 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(torresism @ Nov 16 2008, 10:44 PM)
u sure o nt?

then u are the person to get 2nd chance to "break in" from the same car chasis... laugh.gif

bt hope ur car is okla...
*
it would be great if can change new engine....mean he got more than he pay for
and warranty start over again...
syok drool.giftongue.gif
MR_alien
post Nov 17 2008, 12:09 AM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(ProX @ Nov 16 2008, 10:59 PM)
They are waiting for technical guy from proton HQ to have their last check to confirm whether my car need a replacement engine..If they cant figure out what happen, they got no choice but to replace it..i guess they are running out of idea...it has been a week i left my car..

It is rattling sound.."tet tet tet.."....doesnt sound like wiring problem...if you can imagine, it is like diesel engine running (lorry)
*
ooooh....i thought u have the duuuu sound...should describe earlier..haha
tet tet tet from engine bay...hmm...dn't know..maybe other member know
if change also nice....got more for what u pay for


Added on November 17, 2008, 12:10 am
QUOTE(ProX @ Nov 16 2008, 11:15 PM)
they have changed mine...however, the noise is still there...apparently they have dismantled the whole engine to check for the root cause..till now, they are unable to identify
*
when will be sound come out??....all the time or when driving or when idle?

This post has been edited by MR_alien: Nov 17 2008, 12:10 AM
MR_alien
post Nov 17 2008, 12:13 AM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(torresism @ Nov 17 2008, 12:11 AM)
mr. alien, sounds like u are more interested to change a new engine... brows.gif
*
ya....but this kind of thing is rarely will happen

MR_alien
post Nov 17 2008, 09:31 AM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(djboycalvin @ Nov 17 2008, 08:53 AM)
i planing to change my 13" wheel to 15" ...
cause now i running 100km/h,
i feeling like .. my car not stick on road anymore ..
not stable de feel..
*
u mean will buang ah??...mine always will
and ask all of u.....when some very big car pass me like lorry....why the car will buang abit...go to the side abit???
anyone knows?
MR_alien
post Nov 17 2008, 09:50 AM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(SiuYi @ Nov 17 2008, 09:33 AM)
MR_alien
normal la tu..newton's law mar..lorry carries much higher air pressure when it passess u..even a fast car passing u when ur at a stop will make ur car shake la.
*
shake yea...but buang??
the steering kinda go to a side.......
MR_alien
post Nov 17 2008, 12:41 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(SiuYi @ Nov 17 2008, 11:03 AM)
MR_alien
because the force of air from the heavy lorry push u to the side mar.biasalah too..pasal tu, u must potong lorry fast if u saw them near u..dun let them drive juz side to side with u..very dangerous.
*
haha...ya....
van also will make me go aside too
car won't but only fast one
but our car is 1 tan+ oh....weird this will happen
we are much more heavy than any 1.3L car

This post has been edited by MR_alien: Nov 17 2008, 12:42 PM
MR_alien
post Nov 17 2008, 05:49 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(torresism @ Nov 17 2008, 01:56 PM)
just go ahead.. notworthy.gif


Added on November 17, 2008, 2:55 pm
mayb bcos of our car door is kosong? laugh.gif
*
ya...i think of that as well....no soundproof thn will buang
cuz my dad's waja dn't have these kind of prob


Added on November 17, 2008, 5:51 pm
QUOTE(bozerman @ Nov 17 2008, 05:01 PM)
I drive my dad FORD ranger.
Bus pass by also feel shake la.
So, don worry.
*
i know it will shake.....i mean buang mean the steering will throw to the side...the car will suddenly go to side

This post has been edited by MR_alien: Nov 17 2008, 05:51 PM
MR_alien
post Nov 17 2008, 10:10 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(SiuYi @ Nov 17 2008, 10:07 PM)
MR_alien
simply our car is taller and lighter than other saloon cars.thats all.ask a kenari, they will oso buang to the side.
*
kenari not same...for me lah
kenari square.....since i saw kenari...i already think it's not stable
turn harder i think the car already will flip....haha
MR_alien
post Nov 17 2008, 10:19 PM

Mr.Alien on the loss
*******
Senior Member
3,580 posts

Joined: Oct 2007
From: everywhere in sabah



QUOTE(willie90 @ Nov 17 2008, 10:17 PM)
but if u all say no soundproof then will buang bullshit la.. wat theory o..
*
dn't know ....i think it's the door...totally empty..
if soundproof which makes the door heavier....maybe it will be better...maybe

17 Pages « < 8 9 10 11 12 > » Top
 

Change to:
| Lo-Fi Version
0.0460sec    0.47    7 queries    GZIP Disabled
Time is now: 4th December 2025 - 04:06 PM