QUOTE(St0rmFury @ Sep 20 2008, 12:11 AM)
Help! Newbie here!
I asked a question in the modeling thread but it doesn't seem to be answered yet.
Some of my SeeD Gunpla's leg joints has become a little loose and its hard to pose them without bending over backwards because of their heavy striker packs. I heard from a friend that I could coat the joints with a thin layer of elephant glue to tighten it but he has never done it before and I'm scared I might screw up.
Can anyone here guide me?
Erm, since u said no answer there yet.
The rough idea is like this:
1/ apply thin layer at the hole of the joint i.e. the female/lobang part.
2/ U then insert the male/batang part into the female/lobang part.
3/ Let the glue settle for <1 sec, otherwise it'd be stuck.
4/ Separate the male/female connecter
5/ Clean up any spilled up glues
6/ Let dry.

p.s: Lolwut i just realised it sounded like some 'situation'