Or maybe you could paste a thumbnail here as some of the others guys do.

Hi what WC set are you using?

Thanks 1001010.

@sukatra_aicaca
what's wrong? what's wrong?

I think he is refering to another thread....

Ya use cable ties & cable base to tie the cable ties to. If you use the tape, it will get sticky over time n it will be a mess.

Some casing is not possible to route the cable at the back of the Mobo tray as the clearance to the side panel is small. The side panel will not close after routing through the back

I have posted it in the coolermaster thread, but decided to also post it here.

Just to share what i did with the sleeving on the 24pin ATX.
I had to do a double sleeving as if I only sleeve using the braided sleeving, it will not be completely black and the color of the cable will show through the sleeve. So i first sleeve it with black heatshrink sleeve, then only sleeve with braided sleeve.


Start sleeve.A finish sleeved cable beside for comparison.


First layer finished


Second layer


The other end

This is the Finish cable management on my ATCS 840. I'm using Gigabyte odin GT 550W.
The wires will be a little stiffer, but i was using the more flexible type heatshrink(Japan). So it is still ok, and i was only sleeving the cable extension.


Finish work


All cable sleeved


close up






CCFL Inverter location 1


CCFL Inverter location 2


The messy part

Feel free to comment.

Ya, I know that, i broke 2 CCFL inverters B4. I put it beside the HD without any air ventilation.

That's y this time i put 1 on top near the top fan and 1 on the bottom near the intake fan, it should be enough ventilation this time.

I throw it away n bought new CCFL.