@FoxNope
The fins could be bent a bit to fit through the cable loh ...

@Volt
Just sleeve it and fix neatly with cable tie and zip base ..

@Prodigius
Chun case, hardware and cable management .. 5 Start !!!

absolutely nth to say loh .. .

They do but at a different stall only mah ...

Too bored with own creation of chicken rise .. .

Whenever I'm looking at new case with PSU at bottom of the case ...

Just feel that it's hard to manage the cable ..

@kazairol
Nicely done,, superb for stock condition..

just sleeve the remaining cables that enermax forgotten to do it loh ..

@Volt
Show a photo of the other side of the case ..

Want to see how much u have utilised the space there to hide cables ...

@Fuji-San88
sleeve the remaining PSU and arrange the sata cables a bit loh ..

try to hold the sata cables into single bunch. ...

for the 24 pin mobo connector leh ... I think u better leave it loh ..

too hassle to tackle those ...

@hypermax
bro .. u make me drool loh with ur setup ..

mine so char liao ...

I used to do it before ... now .. lost outside MY ..

It's not that hard .. just try yourself ..

err ..phone cam flash light has limited range

from the distance u took the photo ... I think flash light isn't enough..

try to get a study lamp to point on it .. loh

arrr .. how I wish I could be in service ..

I did few before ..

just learn up yourself or ask some forumer here through posting ur photo right here ..

I'm sure all of them could provide valuable info ..

u could get the effect if know how to setup ur camera.. and provided ur DC got the settings.


1. Turn off flash
2. Use tripod or something else position the camera
3. Increases ISO setting in the camera
4. Use timer, 5 or 10 seconds.

btw, make sure the room light is not too bright or dark.

welll it is a bit hard to hide canles when there is no hidden corner or compartment ..

another thing is with PSU that has short cables .. u cant really have any flexibility to routeit ..

that's why ur 24 pin atx is exposed ..

so far .... cable management so good ...!!

@hypermax

sleeve those cables bro ... make it consistent ...

u got a wonderful case there ...

@syafix
that's akasa case, mirage 62 if not mistaken ..

very nice case with wider than average case for cable management ..

it's alright...overall sort of neat .. it would be better to use Sata connector rom and HDD .. make cables less visible ...

the only thing i'm not getting is why everyone these days choose case with PSU at the bottom which would make cable so visible and difficult to hide.

@bowerchung
get some cable tie base and zip tie to route your cable more neatly. especially those extra cables that u chuck into the CD-ROM cage ..

try to route it to the other side of the case ...

that would help to reduce the messy looks inside.

@atomik
u could really need some sleeving work to get the cable looks neat ..

then only u could arrange it out using some cable tie base and zip tie...

OMG these is a mess.... try to straighten the cables and route some of it behind the HDD cage.

besides that, dont put UV CCFL just next to the mother board because u would get minimal light coverage to lid up those UV reactive component on the mobo.

put it below the PSU and close to the side panel.

those tape wont left sticky residue after a while ?