height = 8ft..

p/s: room include ceiling baby fan.. hehe..

This post has been edited by Redcapz: Jan 10 2012, 10:51 PM

Midea is distributed by Midea Scott & English Electonics Sdn Bhd (a member of DRB-Hicom) which previously distributed Goldstar brand (known as LG now) for many years in Malaysia

Midea air conditioner does have ioniser, plasma features in selected models.

Went to Legend yesterday fully prepared to get Daikin (decision made after hanging around this forum),

After negotiations with the Salesman got sidetracked in to buying Sharp

Any comments on Sharp brand

All my 1HP are sharp. Non inverter.

I got Sharp air cond because the salesman claim that
1. Its durable
2. Its quiet (both indoor and outdoor)
3. Its Plasmacluster technology is the most powerful air purifier.

My 1.5 is panasonic inverter, and 2 is York ion. 1HP is all Sharp.

Because this all fit lower than my initial budget.

phoenix, I am using Sharp as well. 2 units of 1hp with ion for 3yrs so far not problem. how much did you paid for the sharp?

Good to hear that someone is using Sharp and giving good reviews.
This give some relief...phew...
pm-ed the rest of the info.

Pls PM me the details too. Thks phoenix69.

Proton salesmen also claim their cars are the best......

I went to D'Legend @ SS2 PJ. Price should be around the same as I did not bargain cause i did not do initial research on this brand and wanna buy then.

---

Added on January 12, 2012, 9:48 pmThis guy also sell, toyota , nissan, mazda and BMW (has stock some more)


This post has been edited by phoenix69: Jan 13 2012, 09:02 AM

I have installed 7 sets of concealed piping.
Due to Budget not enuff, only getting 3 Air Cond.
The balance air cond piping not used will have ugly piping and wires dangling from the wall.
Any way or products that can cover these up ah??

Buy another 4 sets of aircon.

OK. you could use those PVC trunking (comes in 6' length each) cut them to the required length and cover up the exposed copper piping.

Called york service hotline 130088-#### on 11-01-2012 4pm...for my master room 2hp cassette flipper noise and living 3hp indicater led not lite up when turn on.

Their technician turn up yesterday 1pm sharp as appointment n job done in 30 minutes .

Two thumb up for their after sales service .

Care to share how York managed to solve the flipper noise problem?
Cos, on my Pana aircon have the noise with the air swing. They came 5 times to repair (putting grease, etc, etc)
Till now, still having the noise after few hours of usage. And the aircon are in the bedrooms. Damn irritating

I saw the technician just bend little bit the flipper motor steel leg and reinstalled it. I asked, he blamed their production n Qc.

BTW mine is cassette unit

All my new 1.5 york ion also have a flipper noise problem.....can call york to send technician to my house?

Thanks for the reply. Noticed that your repair was just a few days old...
BTW, mine are wall units. Cos mine immediately after it was done by the Pana technicians, it was OK for a day or two. After that the noise came back again. Probably because the grease that they applied during their attempts has dried up... After few attempts, they even tried to blame it on the circuit board and replace it with no success...

which consumes more power ?

aircond set at 16C, low fan,

or set at 25C , high fan ?

why not, call the number on your warranty card & give them your indoor unit serial no....