planning to order panasonic new deluxe non inverter aircond tmr (but got energy saving 5 star rating so should be not too bad) and get them installed next week

Hello kuchingfight, the Midea air con (inverter) is using the same wiring and piping as the non-inverter type?

yes conventional piping and gas..

the new design quite nice what hp and price u get?

I purchased 2 units of CS-C9NKH 1.0HP for RM1020/unit without installation @ mid-valley last month. free RM80 jusco voucher. so the unit price is RM980.

Couple months ago, my brother get his Panasonic Econavi 1.0 Hp at CLK only 900.

This post has been edited by netcrawler: Dec 9 2011, 07:38 PM

Recently, I am now facing some noise problem (when the vents are set to swing) on 2 of my Pana AC. Reported the problem to Pana and they got their agent and also sent their own technician to look at them. 3 times already. Even after changing the controller board plus the discharge grille. The noise come back after a day or two.

what do u guys think of this pricing for panasonic ac.

pc24mkh - RM2090
pc12mkh - RM1080

s10nkh - RM1250
s13nkh - RM1520

What kind of noise?

It is from the blower unit. Noise comes about when the air vents are moving up & down and sideways. More like some friction in the moving parts. However, the noise is not constant. Most likely when the vent is at certain direction or what. Anyway, it is quite irritating especially at night. So as temp measure, had to turn off the air vent swing.

Thanks for confirming. So far do you think is it on par with the bigger branded air con out there? I am considering midea as well, but then a bit concerns on the reliability thought .

Carrier and Electrolux are using Midea's aircond compressor.

unfortunately, i can only giv u my honest feedback after few months. to my, the inner working of inverter is almost the same across all brands. for 1.5hp inverter, price diff is closed to rm500 between midea and panasonic. so that IS a BIG diff. well, it shouldnt be too bad 2+3 warranty, appliances now, use ->spoilt ->throw ->buy new.

hi guys, want to ask is 2.5mm wires enuff for connecting between the compressor and blower for 1.5hp? thanks
2.5mm wire is cheaper than 4mm 50% 100m coil is rm55 and rm110

Enough.

Panasonic 1.0HP Air Con [CS-C9MKH] - RM899
Panasonic 1.0HP Air Con [CS-PC9MKH] - RM768
Panasonic 1.5HP Air Con [CS-PC12MKH] - RM1068
Panasonic 2.0HP Air Con [CS-PC18MKH] - RM1825

Got this price online from a shop in SS2

I see, perhaps I should consider as one of the option . Besides, do you guys know that for the inverter type of compressor, you would need to empty out the existing coolant before refilling the new one? As for the normal type of air con, we can just "top up" to refill it. Not sure if this is real or not.

Note: Midea inverter can just refill.... that is what I have been told

This post has been edited by cvshi515: Dec 12 2011, 06:00 PM

I have had this problem also in one of my pana aircond. However the noise gone after couple of minutes. I'm sure it cames from the swing parts but I haven't switch on the aircond as I seldom use the room. Will try again this weekend.

---

Added on December 13, 2011, 10:32 amThis price is cheap. Mine to PM me the link. Is this the econavi type without inverter?

This post has been edited by netcrawler: Dec 13 2011, 10:32 AM

anyways, i ON it for the first night tru, first impression..okla..haha juz aircon, set 27C n comfy tru it.

May I know what is the meaning back to back installation? I understand it's aircon installed with the outdoor unit right behind it after the wall. How about install aircon on the wall, the pipe going straight out from the wall to outside then a few feet away to the outdoor unit? Is that considered back to back?

Also, does back-to-back installation requires hacking and cementing back? At first I want to let my contractor settle the aircon cause we want concealed piping (not back-to-back). But he’s slow… so I’m thinking to deduct that work out and only buy air con after we move in and go for back to back. Now my concern is whether there’s hacking and I would need contractor to help me cement/plastering back that area.

Hope my explanation of my scenario is clear. I’m so kucar-kacir now because of the renovation thing! Stress...