May I know your electrolux 7kg front load rm1499 is which type of model?

I looked up the specs for EWP85752  and spin speed is 850 (rpm).
http://www.electrolux.com.sg/Products/Laun...oaders/EWP85752

Seems slow however in Malaysia warm and hot weather, drying in open air should not be an issue. If using a dryer or enclosed place like condo, look for higher spin speed.

SPIN SPEED

The spin speed simply tells you how fast the drum spins in revolutions per minute. Generally speaking, the faster the spin speed the drier your washing will be when the machine has finished. Budget washing machines will typically spin at around 1,100rpm, but look for a 1,400rpm or 1,600rpm machine for the best performance. Our reviews will tell you how dry washing was when the washing cycle had finished.
Source: http://www.expertreviews.co.uk/laundry/129...washing-machine

Spin-dry effectiveness: Front-loaders (and European horizontal axis top loaders) offer much higher maximum spin speeds of up to 2000 RPM, although home machines tend to be in the 1000 to 1400 RPM range, while top-loaders (with agitators) do not exceed 1140 RPM. High-efficiency top-loaders with a wash plate (instead of an agitator) can spin up to 1100 RPM, as their center of gravity is lower. Higher spin speeds remove much more residual water, making clothes dry faster. This also reduces time and energy if clothes are dried in a clothes dryer.[citation needed]
Source: http://en.wikipedia.org/wiki/Washing_machine

If I were you I go for Electrolux, start delay, vapour action, refresh cycle, time manager which non in Bosch.

If you have budget for W85SV why not consider EWF10932? If not mistaken both almost the same price.

Yup,, correct. In fact ewf12022 is even better

blacky? Mine W85SV metallic grey 

then get the W85SV if you don't mind the noise of the pump

It's not super loud just that not as quiet as I may expect

If you stay in klang valley area try this one

Jintex Electronics

He offer EWF10932 for RM2450

too bad he don't have Hitachi FL.

don't go for SSP it's not inverter direct drive. can refer to this Hitachi Catalog

W85SV have white, black and metalic grey 

almost the same price that you post. I got it from Harvey Norman guess it's more expensive than local store, too lazy to go out to town to hunt one. 

Since the water outlet is not there. Likely that it is not original location designed by developer for the house to place the washing machine there. In long run, if u really prefer other location to place the washing machine. It is suggested to either hack the tiles etc to install new water inlet and outlet. I did the same for my house too.

give you one suggestion buy a big water bucket and flush your water from WM there, reusable water to flash toilet bowl 

You can get an extension WM flexible hose same like the outlet WM hose type. It come in 1m, 1.5m or 2m. Extend to the drainage of your desire. And you can roll it back if you want.

My WM is also outside the toilet. The outlet hose is not enough long to reach the drain hole. So get this flexible hose to extend. When I want to use the toilet, just roll back and hang at behind the WM.