Monitor Mod, Attaching a LCD to the casing
|
|
 Jul 15 2008, 06:09 PM
Return to original view | Post
#1
|
 
All Stars
10,530 posts Joined: Nov 2004 From: Petaling Jaya & Mid Valley  
|
the wall mount.....
ur supposed to screw it on ur monitor right??? measure the holes and cut them directly on the side panel....then mount monitor directly on side panel. make spaces if needed. reinforcement of side panel would be needed as well. |
|
|
Jul 17 2008, 12:30 PM
Return to original view | Post
#2
|
|
All Stars
10,530 posts Joined: Nov 2004 From: Petaling Jaya & Mid Valley
|
QUOTE(Maverick_Neutron @ Jul 15 2008, 06:46 PM) Well, that was the plan. But right now, the problem I have is that I can't find the wall mount for my monitor anywhere, as my monitor comes only with the desk stand. I need to find something that will allow me to tilt the monitor and allows gap for the wires and air between the side panel and the monitor. You mentioned reinforcement, could you explain more? Thx. nono.....my idea no need wall mount...the wall mount was just a reference... basically ur wall mount needs to be screwed onto ur monitor....that spot on the monitor where the wall mount screws on, measure them and cut the holes on the side panel....then screw on directly....kowtim. but since u wanna tilt... then either u make a custom bracket or find a tilting wall mount  reinforcement... add metal bars etc etc etc. ur side panel is most likely not strong enough to support the monitor. so ur gonna need to reinforce it to make it stronger to support the weight of the monitor. anyway. ALL IT has alot of wall mounts. tried checking there? |
| Change to: |  0.0152sec
 0.33
 6 queries
 GZIP Disabled
Time is now: 21st December 2025 - 10:51 PM |
Quote