bro,
do u hav an extractor fot exora?

kweng.. i plan to improve my ride mainly on pick up..persona campro IAFM..ur recommentadion +best price for extractor set up and cost?
btw izzit make the engine louder when changing this item?

thanx

bro,
do u hav an extractor fot exora?

Extractor CPS is available, call me for further info. Thank you.

-Weng

This post has been edited by kweng84: Mar 29 2010, 08:33 PM

bro,i using HKS Open Pod on my AUTO car...currently i oledi mod 4-2-1,center bullet(the center of bullet got block one,my friend told me suit for auto car),stock piping,S-flow....so i wanna ask,did anything i mod wrong on my car?
did i need to change my piping to 2"?....for better flow?...cos i using open pod filter

This post has been edited by zzhkszz: Jan 6 2010, 10:29 PM

What car is this?

do u have 4-1 for 4g93 ? PM me. thx in advance.

vios 08" bro..................

4-2-1 extractor
center bullet (filtered/swirling/straight ??? )
stock piping
s-flow (local design or japan 3 tubes design ???)

If you're using OPEN POD (mid-high power) , your rear muffler should go for straight flow and piping you can either remain stock or change to around 1.7" size. The reason why is because OPEN POD filter give u better kick at higher rev, but your current setup is more prepared for kicks at lower rev. It is advisable to go for a straight flow muffler if you are retaining your open pod.

bro......juz asking.....do u have 4-2-1 stainless steel header R3 design for gen2/persona?

pm me the nearest place for me at puchong .... ty

Bro u guys search d or not for the cupping and two springs? I'm facing much problems with your extractor now..

pls recommend what should i modify If i prefer to get more power at low rpm. Persona IAFM Auto, already changed to high flow air filter.

So extractor should 4-2-1 or 4-1?
Center bullet (filtered/swirling/straight ??? )
piping - ori size or ??
muffler - straight or S flow?

Pls quote for full set price. TQ

bro, can recommend me for AUTO setup for satria neo...

wanna change new setup as i have been using 4-1 header (extended type), 1 midbox and muffler...

need to improve on low to mid pickup...

please advise bro...

Can PM me the price for 4-2-1 & 4-1 stainless steel for EG8 - 4DR - 9295 SOHC

Went to Puchong branch and installed full exhaust system with mandrel extractor yesterday(20th) on my Myvi. Can feel alot of improvement.

So far I'm satisfied with kweng84 and his main sifu in Puchong branch.
Very informative. Thumbs up!

Thanks for your support over the other 'brand' u surveyed
If there's any issue, don't hesitate to come back n consult, once again thanks.

Hi, Do you have any extractor for Ford Telstar 2.0i4 V6 body (FS-DE)? How much + installation in your Puchong branch?

Sorry, I don't customize for this V6 yet but if you would like to seek for consultation of it can be worked out, you can drop by my place (please call or text me). Thanks.

hi, kweng can u intro me how to improve my satria neo manual? hows the price? thank you