this is my case...
Thermaltake Armor...
actualy i use this case with thermaltake big water cooling systems but after 2 years i used the cooling system than i gave up...
maintainence fee 4 water cooling system is too expensive coz the coolant will turns dirty n stuck the pipes, that i hv 2 change the coolant and the pipes frequently...
i had change the pump 2 times because the pump burnt cause by the blockage of the dirty coolant in pipes, and spent me a lot of $$ 2 buy better pump...
i changed the processor's water block 1 times coz of the overheat of the processor makes the water block breaks as the coolant cannot flow normally through the water block due to the blockage and the burnt of the pump...
now i oledi study in university that i don hv much time to maintain the water cooling system so i changed back 2 processor fan...
i had used gigabyte mb ga-g1975x so i also use gigabyte processor fan but 3 month b4 i changed 2 gigabyte p5q deluxe mb...
these are the pics of my case...

This post has been edited by samuraiman: Nov 12 2008, 02:49 AM


Attached thumbnail(s)

the above two, which is a cd rom n a cd burner i had oledi sprayed wif silver colour to match my previous silver case n i dont want to sprayed the panel black again coz many works hv to do to respray the panel n my spraying skills not pro enof...
the below one, the dvd burner, the black panel which comes 2gether wif the dvd burner was too common, almost the same as the above cdrom n cdburner. only the ori white attached on it has more sprcial tray faceplate(semitransparent silver)...
all the led light 4 the cdrom and the dvd burner i had changed into blue led...
4 cd burner is twin light, when reading cd is blue, when burning is red...

This post has been edited by samuraiman: Nov 12 2008, 04:03 AM


Attached thumbnail(s)

10q 4 ur advice...
but there is a problem...
the cables from PSU are all so big and hard to bend(coz i m using Enermax Liberty DXX620W model: ELT620AWT )...
i oledi drill some holes at the metal plate(where the mb was screwed on) and use cabel tie to tie all the cabels from the PSU onto it...
i dont want to change the cabels coz the cabel is better(in my opinion). i get the PSU 4 so much $$$ n if the cabels included was low quality than i will drill the PSU n cut n kick n punch n throw n smash n burn n bomb..."KaBoom!!!!!!"... satisfied n go find a better PSU ...
i cannot tie the IDE cabel (at my cd burner n dvd burner) coz i put one 12cm fan at the middle to blow the air 2wards my rams n processor(2 make the air sirculation better)... i can notice a better heat lost from processor n mb after i add the fan ...