Even though i don't quite understand the "settings" as u mentioned. but i do get the last point u were saying...

Yes.. set your modem to bridge mode 1st
then connect the rj45 cable from the modem to WAN port of u'r WRT54G2 router
then connect u'r pc/laptop to the WRT54G2 router access through web 192.168.1.1
change setup to PPPoE & configure it
done!

for WRT54G2 pls check the supported device list of dd-wrt FW
http://www.dd-wrt.com/wiki/index.php/Suppo...ed_til_today.29

WRT54G2 v1.0 Broadcom $45 Micro Only BCM5354 chip rev 2 240 Mhz ? 8 MB 2 MB None / 2 Internals 4 LAN, 1 WAN no ? 12V/0.5A no 203 x 35 x 160 mm ? WIP

Sry, the "Setting" i mean is the router website, it is all will be same, the menu option and the setup setting??
So my router support the FW if my device is inside the list??

almost the same.
check this image for reference/example:
http://ntahx.net/images/setup.jpg

Not all on the list will be supported such as WRT54G v7... pls read-out the "Notes for Running DD-WRT"
as for u'rs u might want to check this page 1st & understand the guides to flash the dd-wrt FW
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=206237#206237

be carefull not to brick u'r routers



This post has been edited by NtahX: Oct 15 2008, 05:29 AM

Thx bro , hope the luck is ony my side, will update here if my router can successful flash the fw. Opps... still working in process, so i m dun have the fw to flash it yet.

This post has been edited by nakata101: Oct 15 2008, 06:04 AM

Flashed my latest router WRT-310N to DD-WRT v24 SP1 std-special. So far it is running fine! and i do realize this wireless router performance is speedier compare to my previous WRT54G V3.1!

This post has been edited by thankyou: Oct 16 2008, 12:28 PM

DD-WRT v24 SP1 is very stable.

waaaa...u have so many wireless clients..

This post has been edited by youliang: Oct 16 2008, 04:31 PM

It shouldn't. Mine is running OpenWRT and I've never rebooted it in about 2 years. Only times it's rebooted are two or three power outages. Still runs as fast as when it was first turned on.

Guys, i just bought a linksys wrt54g version 7 with atheros chipset instead of broadcom. Anything that i can do ? J

One more question ,does linksys provide 3 years warranty for this product ?

Oh nooooo
Can exchange to another version or top up for wrt54gl ???

Oh just get it from a lowyat forumer, he sell me for Rm110, i thought it was a bargain. It is a open box unit. Can consider new. Cause just open and test only.
But anyway i'm getting this for my gf. But i just found out this thread ! But nvm .... if cannot then have 2 stick with this version 7.
My gf only know how to msn and friendster only. The rest i think she wont touch. So i think this is more then enuf since she just want 2 use the wireless in her house.
Another question is linksys provide 3 years manufacture warranty for this ? So if my router strike by lightning the guy from linksys will give me back same version 7 or the newer version ? Just want 2 ask ... guys please help 2 share ur xp here ! Thanks !
If give new version then i put the router to my roof now.. hahaha cause now always raining and thunder striking ! just kidding !

Lightning struck cannot claim oh... Unless u got some method to spoil it without burning the ic...

They will change u to the same model unless they don't have WRT54G with the same version you might get a different version.

FYI V7 is the worst version of Linksys WRT54G router

Worst because of the Atheros chipset and cant support third party firmware ?
If normal internet surfing ok or not. My gf only use in her room.
Any "ahem" skills you guys know 2 claim the warranty ? Last time i flash my linksys wag200 firmware but suddenly no power supply. Then i send the router back for repair. Is beyond repair. Those guys just give me a new set after 3 weeks.
Possible 2 "ahem" the router ? 3 years warranty right ?

hi I'm new planning to buy a brand new router, there's few questions I want to ask all sifu regarding the linksys router.

1) Can I check the modem status( SNR Margin ) through WRT54G/L/S router?
or
I can directly check through by using DD WRT 3rd party firmware
or
I still need to do the manual way which is connect my modem directly to my pc?

Aztech 600E --> Linksys router

2) Can Buffalo WBMR G54 modem router flash with DD WRT? Is it better compare to seperate modem and router?


Anyone can enlighten me ?

thanks alot !

This post has been edited by pisces1529: Oct 24 2008, 05:09 PM

hi, which router have a high c/p rate overall?(sure with ddwrt enable hardware!)

did anyone were selling buffalo router here?(or belkin much better?)

Hurmm... Uptime issue la...after 5 days or so operation time it become unstable (web interface cannot be accessed & bandwidth transfer rate become slower n slower)... I'm not doing BT or heavy download - need to reboot it.. after that everything works fine...

Even though..we can set the auto reboot (cronjob)

Firmware: DD-WRT v24-sp1 (07/26/08) std-special
Time: 19:22:44 up 5 days, 12:32, load average: 0.16, 0.19, 0.09

This post has been edited by NtahX: Oct 23 2008, 07:26 PM

mines stil working perfectly..more than 5 days already.. (repeater mode)

Mine also working perfectly no problem at all all my clients hotspot all deployed using dd-wrt :-)

Hey all sifu,

I have just flashed V24 sp1 std (using wrt54gs v4). Evrything go fines, except for when i go into [STATUS - BANDWITH], the page will ask me to open or save a file with the file name of [graph_if.svg] for 3 times. afterthis, the page doesn't show anything. Please advise me.

Another thing, how to setup a hotspot with using this router? Is there any page tutorial regarding to setting up a hotspot?

Million thanks