arghh... i think i bought the buggy 1 out of 1000 TPOWER I45 here..

I try to run CF on this mobo with HIS HD 3870 + Gecube 3870 Turbo 3.
But there's NO CF AT ALL. still running as single card.

Solution done so far:-

Switch all JPE1 - JPE9 (Crossfire Switch Jumpers) from 1-2 to 2-3 as instructed in the manual.

my GPU-Z detect "ATI Crossfire Disable" but at the same time: GPU-Z detect my Bus Interface: PCI-E 2.0 x16 @ x8 2.0 which is as explain by biostar this 2 pci-e 16x will run at x8 when crossfire enable.

My 2nd GPU oso very cold seem like no activities at all.

help help help aaa sifoo sifoo here...

TQ in Advanced..

This post has been edited by dee_death: Sep 15 2008, 03:45 PM

This is what i did already.. not working at all. haishhh



How to do that? I've been hanging around the CCC but cant see anything like that..

The problem is.. There are NO CROSSFIRE below the ATI Overdrive menu.. uwaaaa... seems like my CF setup couldn't recognize by BIOS itself.

anyone trying CF with this mobo? mind to share your experience?

For your information, i trying to sweep between these 2 cards to the primary slot and both of them running fine and perfectly.
i think there is something worng with the secondary slot there.

Aready with the newest BIOS bro.. wonder what happened with my mobo... emm..

ok i'll try.. this 1 never try? boot with single card but all jumper set to crossfire right? tq 4 the suggestion


i got 2 bridges oo bro.. try both of them ady.. not to avail ... haisshhh
AFAIK, all jumpers is fine. no missing.. except.. ermm maybe disconnected.. try to check it later by sweeping the jumpers each other.

Finally got a solution for my CF issue. Haish.. seems like the jumper is a bit loose, when i sweeping the jumper each other, then my CF is up like a charm.. hampehh betul laaaa..!!! thanks anyone that giving so many solutions and opinion.. let rockin this BIOSTAR board..

Browse your Driver CD. It was there.

i think this mobo is very selective on RAM. i cant boot at DDR2 1100mhz with my 2x1GB OCZ 9600 2.1V (1200MHZ). Need to run with single stick (1GB). it even cant reach 1200MHZ with single stick. I wonder if my ram is faulty or this board.. any one try OCZ 1200MHZ with this board?

i start thinking to sell either my mobo or RAM.. hahhahah

This post has been edited by dee_death: Feb 15 2009, 10:41 PM

Anyone can justify this _weird_ temperature detection? I'm happy with the temperature but afraid if either my board or processor wrongly detecting the temp..
thank you.

Full LOAD


As you can see in OCCT reading, each core are : 71/71/68/68 BUT the CPU is 51. is that correct?

Idle


When idle, 52/54/51/51 and CPU is 30.

This post has been edited by dee_death: Feb 19 2009, 10:31 AM

i'm using the latest BIOS P45AA513 ... but what the hell... i cant run my previous 3.6GHZ with same setting.. i'm using Xeon Quad Core X3320. owh my gosh... i try to up Vcore.. not working...

Then i try to run at 3.33 (i'm using this for a long time before) and my windows will up only for 30 minutes before it restart.

Anyone using this BIOS and still can managed their previous OC? please share here..

Thank You!!