keros-fire rig i see here
wait i try to read pictars
ok, just trying my best
jumper free:
PEG = PCI-E Graphic, setting i dunno
CPU Overvolt give you more fine control on Vcore
AI Clock Skew is RAM related

CPU config:
MTRR my mobo also has it, didn't notice any different change from continous to discrete
HT linkspeed, what option you got inside?

memory config:
memclock mode put it limit should come out another menu so you can limit your RAM speed ( DDR400(1:1)/333(5:6)/266(2:3)/200(1:2) ) while overclock thru CPU frequency (stock 200MHz)
MCT timing just like the usual CL-TRCD-TRP-TRAS-TRRD-TRC-TRFC thing
MCT extra timing you need to play around
burst length 4 for stability, 8 for performance

ECC config:
just leave it / disable as you don't use RAM with ECC

HT config:
HT linkspeed again? i think you can keep it high as ATi chipset can go very high HT speed from TA690 (AM2 thread)
CPU-NB linkwidth keep it 16bit (16↑ 16↓ thing)

This post has been edited by ktek: Apr 11 2008, 10:45 AM

your CPU speed is high (3.0GHz) but why the superPI result is so bad
when 3GHz usually people already break 30seconds for 1M test.

gtoforce, it's time to tweak RAM
otherwise i rather to use stock 2.6GHz speed if no improvement.

not just the RAM, i feel some other things gone wrong
the result is way too off from causing by RAM.

this is the worst possible timing i purposely set except dual channel i lazy to take out RAMs
running 2.9GHz. DDR323 (1:2 divider) 3-4-4-10-2T

gto, divider table for RAM
[attachmentid=475587]
taken from DIY-street forum