hi i wana ask because i owned a Coolermaster Xcraft Xternal Enclosure which one to change the jumper to >???!

This post has been edited by johnkor: Mar 9 2008, 06:15 PM

external no need jumper

Ya, no need to set any jumper to your HDD inside the enclosure.
If no mistake, my HDD inside Enclosure is set as Primary / Cable.

but i guess it wont affect anything, in BIOS only detect it as USB Storage.

yep correct

how to see ah ! damm confused !

See what?

Jumper no need set for external hdd lar

no i said normal HDD when u brought is which one ??

if you're talking about 3.5" hard disk drive, the standard / factory jumper parking position should be on
cable select.
2.5" hard drive doesn't require a jumper. so does sata hard disk.

so when u plug in or use ur 3.5" as a ext hdd use back ori the Calbe select or MASTER and my HDD is seagate Barracuda 7200.7 200GB duno where to see the diagram !@

PICTURE LINK :: http://www.seagate.com/images/support/en/u..._family_pic.gif
(It's from seagate for your HDD)

if you're not sure and feel unsafe using that.

can use this INSTALLATION GUIDE (it's PDF Format)
>>> http://www.seagate.com/support/disc/iguides/ata/cuda7200ig.pdf
(Check your model number in the installation guide to confirm its work to your HDD)

Different manufacturer uses different pin.

Just refer to the hdd itself should have pic on it

but usually the first pin is 4 master.
slave no pin

so which is which ! damm bluur la !