Welcome Guest ( Log In | Register )

Outline · [ Standard ] · Linear+

 New Electric Guitar, Going from Acoustic to Electric

views
     
supercolossal
post Feb 29 2008, 09:30 AM

On my way
****
Senior Member
620 posts

Joined: Oct 2006
From: Penang, Malaysia


Floating means that the bridge is not screwed down to the body of the guitar. Instead it is held floating/balanced/pivots at the bridge studs. It balances the tension of the string with the springs it has underneath.

A strat synronized tremolo is not actually floating per se because it only allows diving but not pull-ups. A true floating bridge will allow you to do both - floyd-rose trems typically.

Of course, a true floating bridge system will also come with the locking-nut set so that you can clamp down the strings after tuning to keep them in tune.

This post has been edited by supercolossal: Feb 29 2008, 09:31 AM
supercolossal
post Feb 29 2008, 09:40 AM

On my way
****
Senior Member
620 posts

Joined: Oct 2006
From: Penang, Malaysia


QUOTE(bman @ Feb 27 2008, 01:11 AM)
Personally, I think whammy bars are overrated, and they're not advisable on lower end guitars since they go out of tune easily after use, from what I heard lah.
My friend said if wanna get a guitar with a whammy bar, get one with a locking system, like a floyd-rose or something, yes a b**** to tune but it stays in tune better when you use it.
But the problem is, a guitar with a properly working whammy bar system that stays in tune costs way more, in the 4 figure range. Those bridges alone cost more than my whole guitar, almost twice the price!

My cheap squier's whammy, I seldom use, and even then I've already messed it up and caused the screws to strip inside, but luckily managed to get it out. If it breaks inside, I would have to spend a lot of money to get a new bridge, maybe 3 figure sums.

A slight 'bent' with the whammy bar when you use it enough of times, would cause it to strip the screw holes inside and you might never be able take the whammy bar out again, without grinding and getting stuck halfway out. At least get one that does not screw in like the typical strat, it really sucks!

For simplicity sake, I think I should've bought a guitar with a fixed bridge instead.

But never mind, I locked down my bridge already, so all's fine there.
*
That's quite true. Tuning a floyd rose can be a real chore esp when the strings are new and you have to spend at least an hour or so to stretch them out, retune, stretch retune until you get it. Even then intonating them is tough also give nthe floating nature ofthe bridge. Also some say floating bridges kill sustain; not sure about this. Playing unison bends is also a challenge, you will need to really use your ears because the bridge will angle forward whenever you bend a string; and when you are in a gig/performance, just pray that your strings dun break midway or something happens that throw your tuning out of whack. It's gonna take a while to retune them back smile.gif

Somethigns that one would need to consider before purchasing a floyd-rose guitar.

Not sure about the different trems out there, so far Ive only tried the LoTRS on my RG. I'm sure the higher-end Edges, Edge-Pro trems would be way a lot better than mine. smile.gif

This post has been edited by supercolossal: Feb 29 2008, 09:41 AM

 

Change to:
| Lo-Fi Version
0.0150sec    0.68    6 queries    GZIP Disabled
Time is now: 21st December 2025 - 06:05 PM