well bro,i sold my ATX long long time ago,now still got myself a IP35-Pro,use it a while first only switch to SFF,going to hang my Stacker STC up and keep it as Antique
which SS and which LL is nice?



U go order LP Jr from John.
I take ur IP35-pro.
How?
I need a board for my coming proc...

Gaban, my stock arrive today.
So confirm with u later what model.
Hopefully it comes with an X...

eh bro the ram still runnin D9 chip ah?

As high as the board will let me go.  It's only rated for 800 though - so I'll start with a 800 OC'ed to 1066 on a PC-6400 DIMM.

I tried my Corsair ValuSelect DDR 667 - wouldn't OC at all without hanging.  Obviously not meant for that, but even slightly upping the speed would cause the system to crash.

huh?!  i think i need you guys to come over and teach me how to do that....seriously.

from 533 to 1260 on value ram?!

ok im going to try it now...dont worry i won't blame you if i cant post on LYN after my ram smokes up. =)

---

Added on September 5, 2008, 2:57 amoh sh*t, im up to 800Mhz so far using CL5 and 2T.

It's stress testing, but I think I'm going to up it some more *shaking nervously*

---

Added on September 5, 2008, 3:13 amIt won't POST past 1:1 ratio.

Even though I've requested 800MHz, It's actually clocked at 775MHz right now, which is in-line with my FSB frequency of 387.5Mhz (x 8 = 3.1GHz OC).

The next step is 827MHz, where it won't boot.
So I'll stress test @ 775MHz for now, but it's better than 667MHz.
I haven't adjust vdimm yet which will be the next step.

Thanks for the advice guys.

Dun listen to KC...
He use wat mobo and wat ram chips?
Those are selected chipsets lar...

You try pump a stick of value ram with elpida to 2.65 and see, i doubt it will last long...

His personal record was set on performance rams and also Asus MIIF.

Btw, do check if your ram mobo vdimms are accurate before going beyond 2.2v. If your mobo is overvolting and you push to 2.6~2.7 then aloha...Bye Bye...
These 2 Tanjung Rambutan gang...
Woit, here POC lar, not POGC (Penang Orang Gila Club).
Wanna gila go far far...

I bid RM51.5...  

I tried running the next step up - which is 827MHz.

Wouldn't POST at stock voltage, raised from 1.8 to 2.0 and after 1hr of stress testing, computer crashed.

Tried again, lasted about 2 hours and crashed again. 

I didn't want to up the vdimm on the value RAM, so I settled back down to 77MHz for now.  Will order some OCZ Reaper PC-6400 2x2GB this week and try again.

Thanks for the advice.

KC and gang, anyone going to KL next month?? yamcha anyone?

pals,

penang mana ada shop sell razer goliathus?