Micro ATX with build in 380w psu.


380w with rtx3050....


Tear off pci covers.


The only fan port in the casing is 8cm.


Front panel


Back side cannot open


No on/off switch.


HDD plate.


Can mount additional HDD at the base.


Short feet.


I like the curve. Simple, easy to clean.




Overall, a nicely shaped small casing that can fit a matx mb. Easy to clean, light weight.
What I don't like is the barely enough psu for modern computing requirement. Why 380w? It is a standard psu form factor, it should has been a standard 500w at the very least. The build quality is passable, material seems flimsy. I dislike the negative air flow pressure design of the casing, the back side should has been totally seal off to reduce dust since it won't help with air flow at all. The front panel I/O is outdated and disappointing.

For those who need a really small desktop, I can recommend this only with an upgraded psu. Even if you are not going to use a dedicated gpu. Also, I recommend to add on rubber feet's.

Offfice pc? So 380w

If want a proper MATX tower with small footprint, get thermaltake tower 300. This pisspoor casing & PSU combo is only suited for i5/R5 office PC running on iGPU. Any GPU will choke inside this case.

After opening the screws package, found that it comes with foam feet and a couple of nylon standoffs.

Hai.....

12V X 20A = 240W

Yeah, that's cap ayam grade power supply. I would advise getting better power supply since you are using RTX.

Have to tie down the cables.