Lianli knock off molex casing fans,


The bottom part is all meshed, but no casing fan air flow can reach directly.


1 3.5", 2*2.5"


SATA powered argb hub, if the rear 2.5" is occupied, not much safe space to stick it on.


Side fan tray can be removed.


2 rows of ziptie hooks on the side, top, and single row at the back.


PSU dust filter.


Top filter and buttons. Kind of rare these tier of casing has usb type c.


Only 1 slot of cover is reusable.


The whole frame is very sturdy


Mesh base and plenty of openings for cables.

No space at the side for cables.

Segotep sell affordable stuff which are esthetic leasing but is it good ?

If small mb OK lar. If standard matx like the cabling née to spend more time.

Cable



How can they not think of this when designing this casing...

This post has been edited by samftrmd: May 31 2024, 01:57 PM

quality u get is what u pay for lar. better go for other brand if ur parts are mid tier and above.

kesian ts kena lockup in basement ...
so dark...

Ehhhh. Whyyyyyyy.
Looks nice already until...

wtf
i puke

the 24 pin connector cannot route through the top?

No, the front panel cable block. If take out the front panel cable first can fit in, but I don't want later user change psu time cannot easily remove.

This post has been edited by samftrmd: May 31 2024, 02:46 PM

Another different build using the same casing. This time I sped extra time to route the 24 pins from the top. I say this takes a lot of time just to do that. Visually, not pleasing by much as well.








This post has been edited by samftrmd: Jun 20 2024, 02:15 PM