Any brand/model recommendations to replace a toilet bowl with a 540mm floor trap. Normal is 10in-250mm but mine is 540mm.

Only 500mm unfortunately and Puchong Bath Innovations said offset not recommended or cannot be used with those models.

Actually I'm not 100% sure of the rough-in because I don't have the model number for mine as well but I'm sure its around 545 by measuring the pipe outlet from the false ceiling and other drain pipes to minus the tile/moulding thickness. If I measure the wall to the bolt, its 21in ~535mm. The 550mm (Asher C118S T88P) could be too long.
I could use a spacer but it could make the toilet abit too close to other things.... thinking of getting a contractor to change the outlet to standard 10inch.

This post has been edited by atilla: Mar 22 2024, 07:20 PM

It will be better to get a one piece design if there is a gap btwn the wall so that the cistern can't shift/fall. The depth of my Inax is around 75cm which is abit long since other brands are typically below 71cm.
If you want to get replacement parts for the Inax, there is an online seller Kiaoranax/Kiaquest.

Pushing the toilet bowl forward might make it too cramped near the sink.