Home Networking Cat6 Not Detected, New Cable in the house not detected
|
|
 Dec 18 2023, 07:30 PM, updated 3y ago
Show posts by this member only | Post
#1
|
 
Junior Member
163 posts Joined: Jul 2012 From: KL 
|
After lay some new Cat6 cable in the house, the new cable seems not detected by the new unmanaged switch (Tenda )
Current setup cable 1 ) Modem - Switch - Mesh/Node(Tenda MW6) - CCTV (Working ) 2 ) Modem - Switch - 4 new Cat6 Cable ( There isnt any light flickering on the switch ) Do I need to do some configuration on the Huawei Modem? |
|
|
|
|
|
Dec 18 2023, 07:32 PM
Show posts by this member only | Post
#2
|
Senior Member
1,006 posts Joined: Sep 2014 
|
Check your cables end to end make sure there's continuity from each pins
|
|
|
Dec 18 2023, 07:32 PM
Show posts by this member only | IPv6 | Post
#3
|
Senior Member
9,050 posts Joined: Jan 2003
|
Could be a cable break or bad connectors.
|
|
|
Dec 18 2023, 08:33 PM
Show posts by this member only | IPv6 | Post
#4
|
|
Senior Member
2,615 posts Joined: Nov 2020
|
QUOTE(VireCwx @ Dec 18 2023, 07:30 PM) After lay some new Cat6 cable in the house, the new cable seems not detected by the new unmanaged switch (Tenda ) You cannot connect it like that, only one port of the modem works and that is used to connect to your routerCurrent setup cable 1 ) Modem - Switch - Mesh/Node(Tenda MW6) - CCTV (Working ) 2 ) Modem - Switch - 4 new Cat6 Cable ( There isnt any light flickering on the switch ) Do I need to do some configuration on the Huawei Modem?  Your setup should be like Huawei Modem -> Tenda -> Switch -> your devices |
| Change to: |  0.0125sec
 0.45
 5 queries
 GZIP Disabled
Time is now: 21st December 2025 - 09:21 PM |
Quote