QUOTE(lonely66 @ Nov 18 2023, 02:00 PM)
just buy 1 of this to use wont be more easy ?
Gas stove ignition needle replacement, for Faber Glass Gas Stove
|
|
 Nov 18 2023, 02:08 PM
Return to original view | Post
#1
|
 
Senior Member
1,263 posts Joined: Oct 2009 
|
just buy 1 of this to use wont be more easy ? |
Quote|
|
|
|
|
Nov 18 2023, 02:16 PM
Return to original view | Post
#2
|
|
Senior Member
1,263 posts Joined: Oct 2009
|
QUOTE(wailing81 @ Nov 18 2023, 01:48 PM) my Faber brand Gas stove has issue with its ignition needle. The original metal part which stick out and 90degree turn at the top part was broken. Place like daiso or diy they do sell spark lighter , replacement spark needle ain't hard if you have very good diy skills if this is your first time ask professional do it , because I'm afraid you accidentally damage the hose or any other thing will causing unimaginable harm.I was trying to replace it. However, I don't find a way to remove it. I tried pull it up, twist it, but it don't even loosen nor shaking. Do anyone has experience replacing this ignition needle? Please provide guidance to me or guide me to the proper instruction. Thank you very much.   |
|
|
Nov 19 2023, 11:24 AM
Return to original view | Post
#3
|
|
Senior Member
1,263 posts Joined: Oct 2009
|
QUOTE(wailing81 @ Nov 18 2023, 04:42 PM) i already bought the replacement needle. Issue is the original ignition needle seems like stuck on it and aint moving at all. Use the pliers clamping flat on the red line don't release hold tight and pull up your plier motion should be similar to orange line , or clamping the green part on spark needle flat surface you can see from the picture twisting right side or left side to try loosen or not then repeat the process from red and orange line again. any idea how to remove it?   |
|
|
Nov 19 2023, 03:37 PM
Return to original view | Post
#4
|
|
Senior Member
1,263 posts Joined: Oct 2009
|
QUOTE(wailing81 @ Nov 19 2023, 03:23 PM) Thanks a lot bro. Is okay tearing thing apart in hard way also part of learning and gaining experience 😁all the grease had glued this part tightly. At the end I hammer and crushed the whole thing piece by piece. on the other hand, I was able to remove another ignitor smoothly without issue by just pulling it up. too bad i started with the hard one. |
| Change to: |  0.0148sec
 0.53
 6 queries
 GZIP Disabled
Time is now: 4th December 2025 - 12:23 AM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.