Outline ·
[ Standard ] ·
Linear+
Sejuk after installing radiant barrier
|
Oltromen Ripot
|
 Jul 3 2023, 04:32 PM
|
|
QUOTE(keybearer @ Jul 3 2023, 12:34 PM) 4. Pretty good results for a low-cost passive solution (no numerical temp. measurement done before / after, but 2nd floor is noticeably cooler in the evening) :thumbsup: [/b] i bought Tuya/SmartLife Wifi-based Zigbee-based AAA-battery temperature+moisture sensor, put between ceiling and roof. It's not so much about accuracy, but in preparation to compare before and after installing ventilators on the roof. At least a measure to know how effective and whether I should install more ventilators afterwards. This post has been edited by Oltromen Ripot: Jul 3 2023, 05:12 PM |
|
|
|
|
|
Oltromen Ripot
|
Jul 3 2023, 05:11 PM
|
|
|
QUOTE(keybearer @ Jul 3 2023, 04:42 PM) Bit too late for comparison 😅, but isn't it annoying though to have battery powered devices above your ceilings? i open the ceiling hatches and just place nearby it, expecting needing to change battery from time to time. at least for a few months while waiting for ventilator stock to appear. i'm sorry. it's zigbee. i check battery just now. both sensors' batteries still 100% since installed early June. » Click to show Spoiler - click again to hide... « |
|
|
|
|
Quote
0.0175sec
0.41
7 queries
GZIP Disabled