Hi I had just had my auto gate installed. It's swing out type but when I open it, the gate will open until kena the pillar. I ask my installer and they said it's normal. I remember my friends' autogates didn't kena the pillar. I'm worried that after some time the pillar's cement will come off or the gate badly scratched.

Thanks, kelvyn.i had call and ask them to instll the stopper only then I pay them.

May I know what's the price for auto gate motor and cabeling for the brand Celmer? My autogate got problem just after installing for 2 weeks (alignment haywire and insensitive remote control) and I wonder if I was given an inferior brand. My neighbour installed their autogate for cheaper price and no problem at all with their autogate.

RM1800, just the motor and cabels.

The brand is Celmer. Yeah, install cable from switch inside my house to the gate pillar. Use back my old gate without doing the bearing.

My neighbour did for RM1700 and include bearing. I don't mind the fact that I pay more than my neighbours but I'm starting to wonder whether I'm paying the price for what I get? Or I was over quote?

So far, comparing theirs to mine, I noticed their gate open and close quite smoothly, remote can be sensed from far. Mine : open and close very slow and now left hand side became slower so currently looks very imbalance. When I press my remote to 'open' then try to press again to 'stop', the gate don't respond to stop immediately. Need to press one more time, only it will respond.

This post has been edited by lowlowc: Feb 7 2012, 11:53 PM

How to say.. the simple 2 button type. One for opening one side only, another to open two side. Press back the same button to stop and to close back.

Not trying to compare price.. but very sakit hati when you see the door doesn't operated as good as you want. Just need to know.. am I paying the correct price for Celmer autogate? If yes, then I accept the fact and ask the ppl to come again and adjust.

This post has been edited by lowlowc: Feb 9 2012, 08:29 AM

Hi guys,

Can the autogate dysfunction if some one cut off the wire at the hand/swinger of the autogate?

I looked at my autogate and those of my neighbours, all has a little exposed wire there, so I wonder what happens if someone cut them. What if you have some kids playing prankster and cut them or burglar?

Is there anything I can add to it to protect the wires?

This post has been edited by lowlowc: Aug 12 2012, 10:29 PM