QUOTE(ycs @ Oct 22 2022, 03:13 PM)
use multimeter to check if got voltage output to right side motor on pcb; in my case, the wire to motor1 was broken underground, so have to replace the wire
no idea how to dismantle plus dont have knowledge for this...
better let pro take care of it while utilise it before making decision...
QUOTE(dblcss @ Oct 23 2022, 09:33 PM)
If the old is very old already sometime is better to just replace it because u won't know what might go wrong with it after replacing one of the faulty part. Most customer would prefer replace the old system then replacing it because if one day u r in a rush to go out and the system give way again then headache already especially for old ppl.
For new system under grd seldom installer want to deal with already because a lot of work to remove the old system and install the new one. Arm screw type will be the most reasonable pricing and if u want simple use only open one or two n close. If Dnor Turbo 880 n DC Moto 924W is more on feature and better outlook n actually not very bulky because the arm is actually the slim type. Only thing for those arm screw or rotate u need a wider pillar to hold the motor bracket min 1 ft or u will need an extra bracket to add on to hold the motor bracket.
Normally up grade from under grd type installer will remove whatever that need to only.
Here is a sample of a recent project we done for our customer at Damansara Utama to replace his old under gnd system to Dnor Turbo 880
https://www.facebook.com/photo?fbid=5799686...799694033414218actually we do plan to install new underground autogate to replace the old one, but seem more practical to install non underground type for future maintainance...
spare part and service are more easier in long term,right?
but my FIL say insist underground autogate are more reliable and long lasting....really?
i wonder how they get those assumption? i dont see any different apart of ugly old fashion design....
frankly speak, we only looking for practical and reliable autogate for long term use....
feature n outlook not important as u can see the old gate are so out fashion but we only intend to change the autogate system for use....
now it take long/few time to open/close the gate are quite troublesome especially during rainy day & oso safety purposes.....
so far, dnor 212k and dnor880 seem quite ok for me....
but due to my pillar size, i think dnor 212k seem better as only require smaller place for the bracket.....
need to measure my gate n pillar size to see which type are more suitable replacement....
btw, anyone use MAG autogate before?
is it good?
my FIL insist of using the MAG autogate for replacement....
so far i only heard of DCMoto and dnor in forum....
Apr 7 2022, 11:04 AM
Quote
0.0938sec
0.43
7 queries
GZIP Disabled