Dear all sifus,

Greetings. Recently was given A new homefibre wifi6 router by unifi (300 package) but am not happy with the performance. Hence i got myself a used rb2011uias-2hnd on v7.12.1 and try to replace the homefibre. After got hold of the unit i try follow bro soonwai method ( terminal via winbox ) to setup my Unifi on mtk but faced following challenges :

1. /system package enable ipv6 [COLOR=blue] syntex error or unknown command.
2. reset-config [COLOR=blue] ok
3./interface vlan add interface=ether1 name=vlan500 vlan-id=500 [COLOR=blue]ok
4
/interface pppoe-client add add-default-route=yes use-peer-dns=yes disabled=no interface=vlan500 name=pppoe-out1 password=fmsSJQEMtvuTy user=myusername@unifi [COLOR=blue]ok
5./interface list member add interface=pppoe-out1 list=WAN [COLOR=blue] input does not match any value of list
6./ip upnp [COLOR=blue]ok
7.
set enabled=yes [COLOR=blue]ok
8.
/ip upnp interfaces
[COLOR=blue]ok
9. add interface=bridge type=internal [COLOR=blue]bad command name add (line1 of column 1)
10.
add interface=pppoe-out1 type=external[COLOR=blue]bad command name add (line1 of column 1).

Any sifu can help with checking n thank you in advance. When ppl said steep leaning curve i guess this is it but its also a tools to learn new knowledge.

Also halfway keying in the command the terminal window disapear, and reappear as new window ( first window content all gone ). Is this normal?

thank you and wish everyone a nice day ahead.

tschong

update 12/3/2024

Now pppoe/wan (ether1) and pc (ether2) and wifi 2.4 (wlan) is running. Wired test to tm speedtest and ookla can get 200 Mbps dl and wifi 20 Mbps dl. Next is to add rest of the lan into the bridge and run local lan speed test as well as add homefiber router as wifi6 AP.

Thanks

tschong

This post has been edited by tschong: Mar 12 2024, 07:23 AM