Hi guys,

Mod almost done. Sent to Uncle Ian to make some holes and cut the side panel. Expect it around this week for the case, but side panel is on queue haha

Anyway, this case is worthy the money paid bcoz not only the case comes with the mini LCD that can do fan control, it has got the temp sensors too. 3 of them to be exact. So, the features inside with the 3 fans alone made this case a very value for money. Just the build quality can't be compared with others. Advantage of the material that I heard from Uncle Ian was, it won't rust easily compared to the Coolermasters.

I think Uncle Ian might make a worklog on the case, not too sure about it, u need to ask Uncle Ian. Its already in BTX form now, not too hard, just remove about 8-10 rivets, remove another 8 screws and u can start to change to BTX oledi. Then drill a few holes to allow for stability, cut a small section of it and if u want, stamp out the back fan to allow better airflow.

From the original fans, I won't suggest u guys to use them unless u don't mind noise coz all 3 are good CFM fan, strong wind but noisy and its not well balance, i left it on my table while powering it up, it rattles the table abit too. Not for me, gonna dump all out in place of the Scythe S-Flex or may Irangan's Noctua Fans(bro, when open ur bulk again, need a few more, Scythe prices is killing me )

Will upload my pics later on. For now, u guys have to ask lehteck for the pics. Shawty, u need to give lehteck abit of time to enjoy his SS KL01 1st haha. Later he will get u some pics.

I'll c if I can get hold of other Encloxure casings to post some pics too.