QUOTE(littleway @ Jun 29 2021, 11:38 AM)
I've been using DT-330 since April until now. Bought it after reading bunch of positive reviews and high recommendations from people around me.
However up until today, I'm still couldn't find the comfortable spot with this chair.
Few problems I have with this chair:
1. Backrest adjustment - The first position is way too upright, and the second position is way far down. It only locks at predefined angle
2. Lumbar support - The cushion is very thin, almost non-existence, and the bottom of the lumbar support wasn't cushion at all. My spine hurts after long hour pressing against the hard lumbar support.
Maybe due to the problem of #1, this affects the #2, or the other way round. I just couldn't find a sweet spot from this chair.
3. Arm rest - It could be better if the arm rest could be pushed further back. There are times where I want to sit closer to the table, but the arm rest is in the way. I have to lower it down all the way, and with that I will lose the arm support. Might not be a problem for other people, since my arm are shorter than the others.
4. Headrest - This is a common problem for most of the working chairs, which is loose headrest. I don't expect anything much from this though.
The good side about this chair is the quality. The entire chair is solid, zero squeaks, and the operation is all butter smooth.
Thanks for detailed review. What's your height ya?However up until today, I'm still couldn't find the comfortable spot with this chair.
Few problems I have with this chair:
1. Backrest adjustment - The first position is way too upright, and the second position is way far down. It only locks at predefined angle
2. Lumbar support - The cushion is very thin, almost non-existence, and the bottom of the lumbar support wasn't cushion at all. My spine hurts after long hour pressing against the hard lumbar support.
Maybe due to the problem of #1, this affects the #2, or the other way round. I just couldn't find a sweet spot from this chair.
3. Arm rest - It could be better if the arm rest could be pushed further back. There are times where I want to sit closer to the table, but the arm rest is in the way. I have to lower it down all the way, and with that I will lose the arm support. Might not be a problem for other people, since my arm are shorter than the others.
4. Headrest - This is a common problem for most of the working chairs, which is loose headrest. I don't expect anything much from this though.
The good side about this chair is the quality. The entire chair is solid, zero squeaks, and the operation is all butter smooth.
Number 2 seems particularly interesting as lumbar support is the main selling point.
Have you tried other chair like Anggun or others?
Jun 29 2021, 08:49 PM

Quote

0.0219sec
0.21
6 queries
GZIP Disabled