Step 1:

Locate the 10 screw covers.

Step 2:

Open the screw cover by using a flat head screwdriver. Insert the head into the cleavage and slightly push outwards and upwards. The cover should pop up easily.

Step 3:

After all screw covers are opened.

Step 4:
Unscrew screws number 4, 6, 7, 8, 9 and 10 (refer to picture in Step 1). Flip the console over and lift up the front cover.
Be careful, there's a connector to the Reset and Eject buttons.


Just displace the buttons in front and pull the whole thing connected to the connector out from the front cover.

Step 5:

Flip the console over. Unscrew screws number 1, 2, 3 and 5. Lift the cover.

Step 6:

Locate the screw as shown. Unscrew it and lift up the top metal plate.

Step 7:

Displace the connector as shown and lift the metal plate.

Step 8:

Displace the connectors and unscrew the screws as shown. Pay special attention to the connector (fan connector) pointed in blue. Displacing the connector could be a tedious job as it's locked deep inside the female jack.

Step 9:

After all has been displaced/unscrewed, lift up the board vertically.

Step 10:

Locate three silver screws as shown. Unscrew them and lift up the board.

Step 11:

You should have something like this.

Step 12:

Flip the console over. Locate the screws as shown and unscrew them. Lift up the DVD-ROM.

Step 13:

You should have something like this.

Step 14:

Locate the screws as shown and unscrew them.

Step 15:

Remove the power switch connector from the board.

Step 16:

Locate the screw as shown and unscrew it. Lift up the board, power switch and the fan.

Step 17:

Locate the screw as shown and unscrew it. Lift up the board (controller ports).

Step 18:

Voila. A nekkid PS2.