Aug 2 2020, 02:33 AM
QUOTE(lurkingaround @ Jul 30 2020, 08:18 AM)
Before MCO, I bought my T8 4ft LED lights and casing from my nearby hardware store. Removed the whole old flour lights and casings(= including starter and ballast/transformer) and replace with the new LED light and casing. Just need to connect the Live and Neutral wires, which connection are reversible, ie can connect either one = easy peasy. Mine is 7000K for full brightness.
LED lights will save you a ton of electricity cost.
..
PS - Anyone knows how to connect 2 such T8 LED lights and casing in series and at different locations(= not next to each other), eg to light up a very large room/space.?
.
I did same way too during mco. Ballast/transformer i no use n throw away, just did direct connection the L and N wire. I did in series 10 T8 led side by side with 1 control switch.LED lights will save you a ton of electricity cost.
..
PS - Anyone knows how to connect 2 such T8 LED lights and casing in series and at different locations(= not next to each other), eg to light up a very large room/space.?
.
Connection in series easy peazy too, u just need to buy T8 that have connector both end side left n right. Its can comes wif 2 pins or 3 pins type, but no different lar. Just buy extra connector and extra wire to connect in series. Giv u example pic.
Mine exactly like this pattern. If for single T8 use only, any connection from both end side would work if connect to on/off switch.
In series, u can connect as many as u want wif this type of T8. If wire not enough long, u can cut and connect wif much longer wire.
This connector is for side by side connection.
This post has been edited by Revoz: Aug 2 2020, 02:37 AM
Quote
0.0239sec
0.94
7 queries
GZIP Disabled