https://www.lazada.com.my/products/unlocked...yFoDoK&search=1



Hi,
Anyone here use this before? Can this work? I plan to ditch the maxis default router by going:

ONT -> Custom router -> VOIP gateway -> dect phone.

https://www.inphonex.com/support/linksys-pa...nfiguration.php

This post has been edited by spamfish: Jul 29 2020, 01:49 AM

hi thanks for the answer. The reason I am going the above route is because my original plan was

ONT -> Custom Router -> Maxis router (Aminia) -> Dect Phone...the internet and wifi works from the Custom router but my DECT phone get an engaged tone. I cant call in from outside too.
Hence to try the above method with the linksys.

Some other ppl suggested going ONT -> Maxis Router (Dect Phone) -> Custom router (bridge mode) but I do not want to use Maxis as the main router however this configuration should be able to work.

Is your

1. ONT -> Maxis c5y -> Asus or
2. ONT -> Asus -> Maxis c5y -> Dect phone

My issue is not with the internet or wifi. Its the VoIP Dect when connected gives an engage tone rather than a dial tone.

Yep bought Ax50 it does not support voip hence need to use back the maxis. I connect Lan4 from AX50 to Wan port of the maxis router. technically should be able to work. But I am getting an engage tone. still trying to figure out why it cant work for the phone.

thanks for the info. Did they say it cant work due to hardware or software? if software future patch might solve this prob.
Oh ya does the AX50 specs says it supports SIP v2 or passthrough?

wow thank you for the info. For the ONT i think it is locked by the ISP. But the rest will give it a try. Is your Archer C5v the default router provided by maxis?

This post has been edited by spamfish: Jul 29 2020, 10:04 PM

this statement is interesting ...is this the reason you connect eth3 to Lan1?

Assuming you did not make the eth3 connection but ONLY the eth4. Can the VoIP Dect phone still be able to work?

this part I understand. I also did the vlan tagging as per your way as well but I am not getting a dial tone but rather an engage tone. High probability is that as per what Jet suggested the AX50 does not support the SIP passthrough eventhough the official tplink says it can. But since you say it also needs the 621 together with the 822 to work I ask the questions.

good to hear that...usually the main aim is to minimize the number of hardware linking...less hop, less issue, easier maintenance.