Well, because you are too desperate to first taste the quad core power... trust me you will make a mistake again next time....

Anyway, whats your proc temps on full load? since you have 8 pieces of 12cm fan inside your casing...

mine 1st q6600 also like that last time...

hardly does 3.4ghz with 1.5v too

but then after go get another one that has a VID of 1.3 n can hit 3.6 with just 1.4v

When u can do 3.6ghz, u will be searching for those chips that can do 3.8ghz later

EDITED: WRONG SECTION. SORRY

This post has been edited by glock88: Sep 2 2008, 09:37 AM

At last managed to get it to run at 3.7ghz


Attached thumbnail(s)

That's a nice OC for the Q6600 ..... but the temperature is

What's the temperature in core temp? And what vcore did you set in bios?

wow...thats a very nice vcore result for 3.7ghz...

ada tweak or non tweak ones?

coretemp same as speedfan.. vcore set in bios is 1.55v, giga p35 ds3 got a bad vdrop and vdroop.

what kind of tweaks ?

oo... i mean GTL or vfsb or vmch actually....

but seems like ds3 takde.....

really good la ur proc can do that clock with such vcore....

last time mine 3.6ghz OCCT pass is gam gam is on that vcore during droop

no GTL, vfsb stock, vmch +0.1v

Later tonite i try 3.8ghz

Temp seem a bit high with WC
What is the t delta?

10c delta

---

Added on September 4, 2008, 9:56 pmforgot to add, gpu is also wc.

This post has been edited by uzairi: Sep 4 2008, 09:56 PM

u shud try intel burn test.i'm quite sure ur temps will shoot up to 80C++. i tried mine on the program. u on few seconds temps already can shoot till maximum . and it fails so easily.normally i use 1.293Vcore to boot at 3.2Ghz.i tried intel burn in test.bios there set 1.33Vcore also can fail the test in less than an hour. i use coretemp for my temperature reading. using prime95 blend test, i get like 58C like dat.using intel burn test, i get ~63C.

3.2ghz no problem bro, at 3.7ghz im using vcore a lot higher which is not good for them.. its just a test run to see wether it can run at that speed or not..

Will try again when i get my new waterblocks, no worries i will post the results here.

What you get

wait and see first

hi all,

anyone could give me some advice on my rigs? trying to oc soon. just for benchmarking....

i tried 3dmark06, it stands at 12,983. At a normal mode & setting. is this ok?

tq vm

This post has been edited by gac: Sep 8 2008, 02:43 PM

Try to play around with the bios and increase the fsb slowly. Try in 10mhz increment and test it using sp2004 x4 if its stable or not.

ok.... tq. can i use prime95? btw, can sp2004 runs under vista ultimate?

i had check up some articles... its says sp2004 can test quad core right?



This post has been edited by gac: Sep 8 2008, 03:13 PM

Yes sp2004 can be used, jus that u need to run 4 instances of it. Remember to change the CPU number so that you are stressing them equally.