Zues u need to get some kick-ass ram. What's with the a-data?

http://ramlist.ath.cx/ddr2/

to check a-data chipset used.

my guess would be 1.55v...dropped and then drooped to 1.496 

not bad kiong,
try to lower down the vcore and try to get as low vcore as u can.

maybe u can try 450*9

cant go any further ald... this new porc at limit ald...

lol same here.... i wan change cpu!!

yes... cause last 2 week i was using FPO:L723, tat batch very hard to stable @ 3.6ghz, this is L724, can stable @ 3.6ghz Vcore 1.475 prime 10 hour ok...

from 3.0ghz OCed to 3.6ghz i can actually notice a lil smoothness on my system.... seriously
keep getting the lowest vcore for 3.6ghz currently 1.4v not too bad eh

tip its not the mhz that makes the difference

its the bus speed in relation to ure rams

thats whats making the difference
except for rendering its pure mhz

---

Added on October 25, 2007, 6:50 pm
yup not bad

x38 now sean can do with his x6800 also at 1.4 kekek compared to last time

i have another question here..
i checked from cpu-z for my e750 1 of the core the multiplier is x6 and  the other one is x8 even though i have disabled the speed step in the bios, y is it so??
can anyone help me pls

hmm..my e6600 idle abt  40c. oced to 3.01ghz 430x7, ram 1:1 5-5-5-12, load 60c (using cpu steb test for 1 hour..i know thats not enough for testing stability but i used in this setting for more than 1 week edi.. ). however, when i use everest ultimate (trial version) to stress my cpu, the temp goes up to 65c 

stock cooler. not yet decided to buy 3rd party yet. i oc just to see how much can it go...
and i found that with the stock cooler.. max is 3.20ghz (400x8), can't break that or pc will keep reboot until default setting or hang or blue screen somewhere during start up (or in window).

wats the difference between biostar tforce p965 and 965pt?which is best overclocker?

I'm running E6400 @ 1.35V on AW9D-MAX @ 1.90V MCH and Corsair XMS2 6400C5 @ 4-4-4-10 @ 2.1V.

The problem - just 375MHz FSB already unstable 
As you can see my voltages are running dangerously high already. I'm not sure why my board wouldn't go any higher.

Memtest returned 5 errors after a test of 2000% coverage. The only voltage I didn't push *that* high is the vcore but I'm pretty sure it should be able to run at such speeds without needing much of a voltage hike. The strange thing is, the memory errors only came recently, about 6 month ago I achieved a stable clock at FSB 381MHz so I have no idea why the instability hits me now considering I didn't change anything at all.



Any suggestions or opinions?