How to remove brushed aluminium stretch mark?
|
|
 Nov 29 2019, 08:50 PM, updated 6y ago
Show posts by this member only | Post
#1
|
 
Senior Member
3,506 posts Joined: Jan 2003 From: Lumpur 
|
I have an anodized and brushed aluminium panel
Originally it was a bit curved outwards so i used some force to bend it inwards to make it flat It resulted some stretched marks on the panel. The mark is perpendicular to the brushed aluminium texture Luckily it can be only seen from a certain angle Any1 know how to remove this stretch mark? I dont think its scratch.. Any metal specialist that i can go? Attached thumbnail(s) 
|
|
|
|
|
|
Dec 24 2019, 04:52 PM
Show posts by this member only | Post
#2
|
Junior Member
376 posts Joined: Jun 2018 
|
Usually that's micro cracks in the sheet , nothing much you could do about it but try to mask it .
|
|
|
Dec 24 2019, 06:01 PM
Show posts by this member only | IPv6 | Post
#3
|
|
Senior Member
3,506 posts Joined: Jan 2003 From: Lumpur
|
QUOTE(CertifiedHomphobe @ Dec 24 2019, 04:52 PM) Usually that's micro cracks in the sheet , nothing much you could do about it but try to mask it . I sticked a sticker over it d Now i feel better Haha |
|
|
Dec 24 2019, 06:17 PM
Show posts by this member only | IPv6 | Post
#4
|
|
Junior Member
376 posts Joined: Jun 2018
|
QUOTE(smokey @ Dec 24 2019, 06:01 PM) I sticked a sticker over it d That works great too Now i feel better Haha  |
|
|
Feb 14 2020, 10:04 PM
Show posts by this member only | Post
#5
|
|
Junior Member
54 posts Joined: Jan 2020
|
I would advise you to let it be the way it is.
You cannot do anything about it. Ensure that you don't damage it further. |
| Change to: |  0.0196sec
 1.27
 6 queries
 GZIP Disabled
Time is now: 18th December 2025 - 11:56 PM |
Quote