Aug 8 2007, 12:10 AM
QUOTE(striderozy @ Aug 7 2007, 11:25 PM)
I have bought a fake SD before.....
And of course, it doesnt fit well also......
But what I have done is try to cut the connector area (what do you all call those? the male and female socket to connect two parts together) to make it thineer to fit into the hole......
But remember not to cut too deep or too hard, then you will break the whole connector, then u will need cement later on.......
Probably not a good way, but just some sharing......
a another way of doing that is to buy drill bit/ or drill head from ACE hard ware / local Hardware story .. buy 1.5mm and 2mm that waht usually all the your male female connector size is .. loosen the hole is way better that u thin ur connector ... if too loose u can always glue them up! right! remember loose joint is much easier to fix than broken joint ... if broken joint also dont worry can always drill will 1mm hole insert steel/pin into it and super glue to hold it ... hehehe talking about reinforcement ... heheheAnd of course, it doesnt fit well also......
But what I have done is try to cut the connector area (what do you all call those? the male and female socket to connect two parts together) to make it thineer to fit into the hole......
But remember not to cut too deep or too hard, then you will break the whole connector, then u will need cement later on.......
Probably not a good way, but just some sharing......
Quote
... Can ... later Lining material now pakai Mr.Hobby Mechincal Pencil ... 0.3mm ... aslo 2B is good for doing Gun power effect ... Dry brushing ....
0.0408sec
0.91
7 queries
GZIP Disabled