Welcome Guest ( Log In | Register )


Bump Topic Add Reply RSS Feed New Topic New Poll

Outline · [ Standard ] · Linear+

> Proton Wira car boot water leak, due to theft break-in

views
     
TSlonginusshortleg
post Mar 10 2019, 03:59 PM, updated 3 months ago

New Member
*
Group: Newbie
Posts: 29

Joined: Dec 2016

Hi sifu!

I have an old Proton Wira and the boot kena break-in once. So now the boot is leaking water whenever it rains. My documents all wet!!! cry.gif cry.gif

Is there any repair service for car boot in Malaysia?? Probably need to fix the rubber and hinge.


Thanks!!
dylan_chng
post Mar 10 2019, 10:45 PM

Getting Started
**
Group: Junior Member
Posts: 292

Joined: Jul 2017

maybe rust.
TSlonginusshortleg
post Mar 15 2019, 09:29 AM

New Member
*
Group: Newbie
Posts: 29

Joined: Dec 2016

QUOTE(dylan_chng @ Mar 10 2019, 10:45 PM)
maybe rust.
*
The boot is out of place because of the theft break in. Is there any car repairman who can fix this?
Deja Vu
post Mar 15 2019, 09:53 AM

Regular
******
Group: Senior Member
Posts: 1,616

Joined: Jan 2003
You can either find a thrust worthy panel beater, or if you're willing to DIY, strip the side carpets/plastic panels in the boot, lie down in it with a light with the boot closed, then have someone water the boot and areas around it.

With luck, you should be able to see where the water is seeping thru.
air_ed20
post Mar 15 2019, 10:07 AM

Getting Started
**
Group: Junior Member
Posts: 240

Joined: May 2006
QUOTE(longinusshortleg @ Mar 10 2019, 03:59 PM)
Hi sifu!

I have an old Proton Wira and the boot kena break-in once. So now the boot is leaking water whenever it rains. My documents all wet!!!  cry.gif  cry.gif

Is there any repair service for car boot in Malaysia?? Probably need to fix the rubber and hinge.
Thanks!!
*
is there any dent whatsoever, if no you can just send to accesories shop like brothers or so to do the rubber change...additionally you might want to check if the key lock is broken which causing the leak...best of luck
speedy3210
post Mar 15 2019, 02:02 PM

Getting Started
**
Group: Junior Member
Posts: 71

Joined: May 2006
Dont think you need any rubber seal change if it wasn't torn or completely flat. All you have to do is trace which location water goes in. normally thru the gap between the metal sheets seam or the gap between body and rear light clusters. over the years, the seal at the light cluster may have gone bad and water can get thru.

Remedy? just get a pack of Blu-tack/Tack-it from stationary shop and cover the leaky area. just make sure to clean the area before applying the Blu-tack. Cost is normally below rm10. Good luck.



Bump Topic Add ReplyOptions New Topic
 

Switch to:
| Lo-Fi Version
0.0673sec    0.63    5 queries    GZIP Disabled
Time is now: 27th May 2019 - 05:13 AM