yeah its 10.5 multiplier for auto on am2 4000+..u can set lower for x9,x10 or else

why want target HT??
target the proc speed is better ar..

1.5v would be ok with decent cooling.
My brisby on with 1.525v @ 3.05GHz last time. Now no overclock already due to electric bills

-pWs-

RM60 just for my PC.
No oc still small case, now with CnQ on.

-pWs-

Haha..no choice bro. But stock speed w CnQ really insane cold. 
I also roughly estimated only.
I live at my relative's house now. Before this, their bills is below 80.
Now i shifted in,their bill hikes to 130-140

-pWs-

just check your Voltage and make sure everything all voltage reading is good, then it should be alright. If its your PSU, the voltage should flunctuate alot and most of the time below the specified voltage.

So sad, my 4000+ brisby already hit its limit. Cant go any higher with my current board, max OC 3.3Ghz @ 1.55vcore, bootable with lots of distortion. 3.2Ghz 1M superPI-able, and 12hours orthos stable at 3.0Ghz @ 501Mhz 4-4-4-7-11-2T @2.3vdimm.

Im sure that my ram isnt holding me back though, nothing else i could do =( 1.55vcore is the highest my board can go. Any suggestion for further overclocking?

Will use it if it is 1GBx2 but sadly just 512MBx2 so use it for OC testing purpose lor !

u dun wan to do V3 d?

heheheh

kesian soulfly.....

hey bro, biostar ar? which model good le? TF560 A2+, TF7050-M2, or TA690G AM2... ? any recommendation?

howz the build in graphic for TA690G AM2? heard some review its not bad thou... was thinking to use the internal display and use the money for a 3-4gb ram mayb? of coz, if the build in display is good la... 

lets say im oredy hav 2gb ram. and if i take the money on graphic card and spend more on ram, i think it'll b more cheaper rite? since if 2x 1gb ram now oni 200+ and a 8500gt cost around 300+

tats y i wanna knw the quality of 690G graphic. if its too louzy... i might change my mind on my taught above...

guyz, plz correct me if im wrong k.   

hi..
i'm using a 4000+ brisbane 65w chip paired with biostar's tf-7050..

how do i set the FSB:DRAM thing? what shd be the ideal setting? currently running 240mhz bus on stock voltage and stock cooling. FSB:DRAM showing CPU/11 = 229MHz.. what does this mean?? what shd the ideal number be like?

all i did was adjust the bus frequency and set the HT to 4x. Ram was locked to 400mhz. is there anything else that i should set to get the optimal overclocking at this speed?

   

bro xixo, i think for now gaming with 1gb only min requirement. 2gb is good  enough. moreover if using vista, 1gb not enough as gaming will be a bit lag...experienced this b4...  

i wonder why is AM2 overclocking thread turning to be onboard graphics discussion...

What's the definition of 'good oc mobo'?
Can the super pi result below shows that TA690G is a good oc mobo?
CPU 3.25G
RAM 1082Mhz 4-4-4-5-2T

oic...looks like my setting failed...need to do back..will down vcore and ram also...