Auto Gate programing, Pairing remote key to control panel
|
|
 Jul 26 2018, 06:00 PM, updated 8y ago
Show posts by this member only | IPv6 | Post
#1
|
 
Junior Member
108 posts Joined: Oct 2013 
|
Appreciate help on the following..
1...To Reset....How many times needed to press the program button on the control panel to clean start. 2...How to set open/close one side of the gates 3...How to set open/close two side of the gates Auto gate is 433mhz, swing gates type 2 switches on remote key No DIP switches on control panel, only program button Cheers . 
 This post has been edited by DragonHorse: Jul 28 2018, 02:19 PM |
|
|
Oct 13 2021, 01:38 PM
Show posts by this member only | Post
#2
|
Senior Member
1,152 posts Joined: Jul 2011
|
QUOTE(DragonHorse @ Jul 26 2018, 06:00 PM) Appreciate help on the following.. There is the "Prog" button. Use that to do programming.1...To Reset....How many times needed to press the program button on the control panel to clean start. 2...How to set open/close one side of the gates 3...How to set open/close two side of the gates Auto gate is 433mhz, swing gates type 2 switches on remote key No DIP switches on control panel, only program button Cheers .
 |
| Change to: |  0.0169sec
 1.10
 6 queries
 GZIP Disabled
Time is now: 20th December 2025 - 09:12 AM |
Quote