snapshot
so i just stick to booklet will do ..lol

OT = Engine Oil Treatment

EF = Dunno apa Engine Flush thing
1st time tak apa ..10k service need to "control" on all these addon stuff

for next project, black interior like iriz 

driving single front 210kpa back 190 kpa

driving with passengers and load front and back 220kpa
keep the tyre pressure around there. over inflate reduce grip, makes the car bumpy and over time induces uneven tyre wear. SC recommend higher because people normally dont check pressure often.

sony xs-fb163e 6.5

Does this speaker fit in persona front speaker, plug and play?

Thanks for the info, when you say drill do you mean drill on the speaker to fit the existing hole at the car or drill at the speaker parts?

Any 6.5 inch speaker spacer will do?

Hi guys, recently contacted bateriku and they offer me Amaron Hilife Pro DIN55 car battery for rm310, why is it more expensive than proton's stock battery? Abit too much no?

I think u nees to put some rubber or sponge on the bottle slot before u put the armrest...

This is mine...
[attachmentid=9838693][attachmentid=9838695]

Might to post your pic? The door visor can see through?

The problem i from east malaysia, here hardly find the door visor, if got also Rm1xx++

Not really what i asked, but thanks anyway
1 - ya, it did occur to me to bring this up to proton directly. but not really sure how. haha. maybe i'll msg them on their fb page.
2 - actually i went to insurance company d, and ya, too late. they said if want to change, next year la. lol. so, this rm400 hangus d.

thanks

Hi guys,

Newbie & new Persona CVT Std co-owner, from Kuantan.

Car about 2 weeks old.

After took of from show room, straight away to accessories to install basic such as tinted film, door visor. During check up at show room, did not notice any issue. Excitement I guess.. hahaha..

After installed the door visor, then noticed that the driver door top edge is not aligned with rear door !!???  Duhhhh.. thinking wat d heck ?!!! How could be door not aligned yet can be shut properly. Further inspection, the middle & bottom section of the driver door are aligned with rear door, just the top edge is not align.

Went to dealer SC, where bought the car, said need to remove bumper , fender.. ketuk2 abit.. start talking about worried bumper rosak & so on... Scare tactics i suppose..

Went to 2nd SC for 2nd opinion, said this is manufacturing defect, and said this is not cover under warranty. Is this true ? How could manufacturing defect not cover warranty ?

How could possible this happen ?? Is it the door mould problem during fabrication process ? Or is it the material out of stock during door production, so they decide to cut abit ???!!!!
Its really sakit mata & feel annoyed look at that unaligned door. Probably because this is brand new car & was hoping at least it will look perfect as brand new car.

OR IS IT NORMAL DRIVER DOOR NOT ALIGNED WITH REAR DOOR ? PROTON , PLEASE ANSWER THIS !

am just wish to get door replacement..

Duhhh.. excitement bout to vanish away every time thinking about the door... Hahahaa

In the service book say first service is inspection only. Why SC say need change engine oil?

Interesting, haven't got the chance to compare yet.

But speed reading variation between GPS and speedo is normal one, GPS is relatively more accurate while speedo can be affected if you change the Tyre and Rim  end up overall wheels diameter is different than stock.

Bought custom made carpet from ottoman for 319. Very good quality. But where to find best and install sun visors? Good ones that can last long. And arm rest.

Hi guys. Any of you having problem whereby your car's temperature suddenly gone up, and aircond goes warm? I'm not sure what causes the problem

I see. Just got an update from SC that I sent earlier this morning.

They found nothing wrong apparently with the car. Hmmm. Should I go to another SC?

Hi bros. Anybody renew their road tax and insurance for 2nd year? Care to share what is the quoted sum insurred? I got quoted rm42k. Last year was rm48k