My 2.4ghz quite powerful tho..

........
IT WORKS!!! Thanks a lot.

after set the region to US, the signal become as strong as RG4332





am i need to set 5ghz to US also even if it is working fine?


This post has been edited by lol0919: Sep 19 2018, 05:55 PM

100mW is default power for most of 2.4Ghz access points for full signal,
i think the problem here is that when i set the region to Malaysia and Singapore,
it get capped and go even below the maximum txpower allowed of this 2 country,
this doesn't make sense as other routers with these countries as region can works properly and this doesn't go beyond the rules,
might be a bug of this version of firmware or some errors in their presets? who knows...

This post has been edited by lol0919: Sep 19 2018, 12:14 AM

Oops sorry i mistaken, not all innacomm router same base firmware as broadcom lol..

do you know which setting from router to solve image loading problems of facebook and instagram?
all devices from my network cannot load images in fb and ig...

That may be the 1.0.0.0/8 route problem. Check the first post.

okay, thanks

No prob, hope it works. are you on turbo speed already? Would love to see a Speedtest. I'm still waiting for 800Mbps so cannot test anything yet.

not yet, wait till neck long already...

i am asking the config file from aztech malaysia... and just get it... need to test it again...

because i reset, it become factory reset for another setting, not unifi...

Can foward their config here? Thks

here the file... need to unzipped first...

 Update_Software_Unifi.7z ( 3.97k ) Number of downloads: 18


i hope i do the correct file attachment....

Thks

please give feedback if already test....

Will test later. Currently using it as ap at my other place without unifi

Guys,

i just bought this router from Lazada,

using firmware 003.

However i noticed that both facebook and instagram cant properly loading. But when using VPN, slow loading not happen..

Anyone with same issues as me?

This post has been edited by lepo: Sep 20 2018, 02:35 AM

That may be the 1.0.0.0/8 route problem. Check the first post.

I already read it but clueless to add that route.

Could you specify which setting should i add?

Thanks

-----NVM-----

Advanced>Advanced Setup>Routing<Static Route

1. Add
2. Destination 1.0.0.0/8
3. Interface PPPo

Done

This post has been edited by lepo: Sep 20 2018, 03:42 AM

I have been interested to get this router for awhile now.

Just asking before I take the plunge, has anyone managed to get both internet (vlan 500) and HyppTV (vlan 600) working together?

Both can works