Jan 18 2010, 08:18 PM
QUOTE(Parody @ Jan 18 2010, 07:21 PM)
Cut out the part you want to use.
Dip the part into water for about a minute or two, or until the decal separates from the sheet.
Put the decal on top of the part you want it to be on.
Move it into position and leave it there.
(Optional - put Decal Softener on top of it, or Mark Setter at bottom of it)
Soak up excess water with cotton buds or soft cloth.
Leave to dry.
(Optional - spray 2-3 layers of Topcoat over the whole kit)
there are how many type of decals except the water decal?how to differentiate? Dip the part into water for about a minute or two, or until the decal separates from the sheet.
Put the decal on top of the part you want it to be on.
Move it into position and leave it there.
(Optional - put Decal Softener on top of it, or Mark Setter at bottom of it)
Soak up excess water with cotton buds or soft cloth.
Leave to dry.
(Optional - spray 2-3 layers of Topcoat over the whole kit)
Quote
0.0477sec
0.55
7 queries
GZIP Disabled