Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed

Outline · [ Standard ] · Linear+

 Honda City Gen 6.0/6.1 V09, looking for new TS

views
     
Assclown
post Sep 24 2017, 10:40 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(outsider @ Sep 24 2017, 10:13 PM)
jsut receives sms from my SA that my city hybrid going to arrived probably next week  rclxm9.gif

by the way ~~ any recommended Tinting? i plan to get 3M, Raytech or Llumar
*
Was told my City will arrive next week too. But not sure which day.
Hopefully by Tuesday.
Assclown
post Sep 26 2017, 10:48 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(outsider @ Sep 26 2017, 08:32 PM)
Arhhh my car is ready but my plate no not ready

Shit ~~ have to wait 1 or 2 day
*
Oh lucky you. I myself saw trailers carrying new Honda cars on the highway today.
But my SA said his dealer have not receive them. I hope they get it this week.
Assclown
post Sep 27 2017, 10:17 AM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(aregip @ Sep 27 2017, 10:08 AM)
Hye guys..! As I promise, the attachments below are the maintenance cost and service schedule for All New Honda City i-Vtec 2017 and All New Honda City Hybrid 2017.. Hopefully its useful..
*
The Dust and Pollen filter is really expensive.
Might as well buy outside and change yourself for a fraction of the price.
Assclown
post Sep 30 2017, 01:04 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(outsider @ Sep 30 2017, 02:14 AM)
Got my car yesterday. Today went for tinting and something wrong happened. The dashboard keep shown smart entry problem. Unable to drive 😭😭😭  Then the tinting worker dry it up the wiring n ok. When on the way drive back home. System pop out again shown my door didn't close. Damn...

Any solution if tomorrow happen again? Should I bring it SC and let them check?
*
Where did you get your tinting done?
Assclown
post Sep 30 2017, 05:45 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(outsider @ Sep 30 2017, 04:31 PM)
Raytech puchong
Now seem ok already and dry up.. last night really omg

Once the system entry pop out and when u stop, it automatically turn to P. There not allow to drive. I lucky enough almost reach home only the system pop out. Else, I really gonna call towing or stop in mid route
*
I planned to do my tinting there once I get my car.
Now having second thoughts
Assclown
post Oct 3 2017, 11:53 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
Finally collected my E spec today after almost one month of waiting.
Went straight to install Modulo bodykit, foot light, side step, Mugen sun visor and OBD speed lock.

Weird thing about this OBD speed lock is the hazard lights will be on about 30 seconds if the doors are open.
Assclown
post Oct 4 2017, 09:43 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(ameri @ Oct 4 2017, 03:48 PM)
Free gift after do online survey
[attachmentid=9200182]
*
What survey is this?
Is it "Update Profile" in Honda Malaysia's website?
Assclown
post Oct 5 2017, 06:20 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
How does a typical bumper gap issue look like on City?
Saw this mentioned few times before when I was planning to get this car a month back.

Does the gap show up only after driving for a few weeks or since day 1?
Assclown
post Oct 5 2017, 08:22 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(babylon52281 @ Oct 5 2017, 08:17 PM)
The rear bumper sweeping upwards to the bootlid. Gap is at between rear bumper & body,
*
Here's mine.




Attached thumbnail(s)
Attached Image
Assclown
post Oct 6 2017, 12:04 AM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(NSX_MY @ Oct 5 2017, 11:56 PM)
Ah damn, did not notice about it until you guys mentioned. My rear bumper left side the gap is smaller as compared the right side, the right side i can see all the clips. Gonna highlight it during my next service, sigh...

Btw, just installed 19mm rear ARB, the handling feels much comfortable now and for some reason the bumpiness from the rear is less obvious now, hmm...
*
What's the price for 19mm rear ARB? Planning to get it too.

On a side note, has anyone with E spec installed tweeter into the empty speaker case at the 4 door handles?
Assclown
post Oct 9 2017, 08:09 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
Anyone installed 19mm rear ARB? Wondering how's the comfort for passengers at the back. Is it too stiff compared to 16mm?
Assclown
post Oct 9 2017, 11:20 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(tysmiracle @ Oct 9 2017, 08:34 PM)
Wanna ask city FL v spec i've been driving for 2 weeks now, my aircond during noon always have to on around 4 or 5 FAN with 22 celcius, AND the wind blow out inconsistent some times bigger by a little sometimes lower by a little without me adjusting, isit normal?

You all also the same or isit just me?
*
My E spec is quite cold. I only need 3-4 fan with 25C on a hot day. At night i'll set it to 26C.
Assclown
post Oct 12 2017, 01:21 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
I plan to upgrade my tyres from the current 175/65/15 to 195/50/16.

With lightweight rims, will the acceleration suffer a lot from the wider tyres?
Assclown
post Oct 12 2017, 06:18 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(eddie2020 @ Oct 12 2017, 03:28 PM)
Just fit?
Nope... For mine not much issue..
*
what rims and tyres are you using?


QUOTE(haoadam @ Oct 12 2017, 05:09 PM)
195/50/16 i think quite hard to find.. why don u go 185/55/16?
*
185 can feel any difference?
Assclown
post Oct 13 2017, 03:48 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
Apparently City's original front windscreen comes with high Infrared Rejection (IRR).
I installed a tint with 95% IRR and smart tag didn't work. Went back to the tint shop and they did a cutout at the rearview mirror area.

Now the place with the dotted lines are not tinted with the 95% IRR tint, just the sun visor tint.
Assclown
post Oct 13 2017, 05:10 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(alesi616 @ Oct 13 2017, 04:57 PM)
Are you using 3M tint ?
*
No, using Rhinepro. And this particular tint no problem for other cars.

Assclown
post Oct 13 2017, 10:13 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(Alexdino @ Oct 13 2017, 04:02 PM)
apparently only Am version of the anycastm2+ can be use for fl hu, so becareful when you buy, make sure it looks like the one in the picture
*
I just received my RK3036 M3 Plus, and can confirm that it works with FL HU.
Assclown
post Oct 14 2017, 12:28 AM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
QUOTE(Alexdino @ Oct 13 2017, 11:58 PM)
Great news. mind to share m3 plus box? thanks
*
Here you go. This one has a dual core CPU btw.

Attached Image
Assclown
post Oct 17 2017, 12:09 AM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
For FL, I noticed there's blue and green color around the middle odometer.

What does the colors indicate?
Assclown
post Oct 20 2017, 09:59 PM

On my way
****
Senior Member
647 posts

Joined: Feb 2007
Just check my 2 week old car's tyre pressure with a gauge. The reading was 300kpa for the front tyres and 280 for the rear. Honda seriously over-inflate from the factory.

2 Pages  1 2 >Top
Topic ClosedOptions
 

Change to:
| Lo-Fi Version
0.1284sec    0.44    7 queries    GZIP Disabled
Time is now: 29th March 2024 - 01:56 PM