One forumer at GameSpot.com posted a thread regarding the way he found out that will keep u off the 3ROD problems. and it's proven by him that 3ROD caused not only by hardware failure.. its the adapter.. I dunno whether any of u already found out but i'm here to share.

Here's da pic of mine (Juz like how that fella did)
ohh ya.. i knw my cable management is bad...







but the difference between his and mine is that;

1. i cut the box to 1/4 horizontal
2. then measure the width of the adapter(a watever is that)
3. cut out both sides according to the width of that measurement(left a bit to be bent inwards)
4. then place the adapter on it so that it can maintain the position of it.

i read that thread... but didnt finish reading it.. it's like 10/10 ppl say it works
so far i didnt encounter 3ROD problem at all(touchwood). Well.. prevention is better than cure
since this is X360.. let the heat from the adapter release 360 degrees too...
jkjk..

This post has been edited by fx2800: Apr 12 2007, 03:05 AM

i juz got my X360 for 2 days bro.. those ppl in that thread say this method works.. try out and tell everyone here if any of u encounter 3ROD problem

some ppl might dunno about this ma.. it's not wrong to spread useful info rite??

This post has been edited by fx2800: Apr 12 2007, 03:16 AM